"Just a heads up ——they are getting hard to find but once in a long while these days
Have a machine shop repair yours if at all possible
You can go on to Jason Edges waiting list as he brings in a car to disassemble from time…"
"Do contact Russ as you need a single headlight surround which he has
The For Sale item is for a pair so he may not want to separate the pair
It is the very first thread when you open — For Sale - posted about 20 hours…"
"Welcome to the 63/64 Cadillac Website.
I show your are a CLC Member and will get you signed up to the Chapter in a bit. Also, welcome to the Chapter!
Be sure and check out all the links and pages and make yourself at home. The Help…"
Hi,I have a huge problem my POWER SECTION of the ``Master-VAC Power Brake unit 9´´Diameter ´´ from Bendix is Broken and I can't open it to replace al the rubber parts did some of you have auch Power…Continue
Did anybody from the club install third brake light in the rear window in his Cadillac? I have problem to figure out how to do it. Can I just run wire from break pedal switch and second wire connect…Continue
Ok, I have another question. Since I will run wire for a brake light I might run speakers wires.I would like to install 2 extra speakers or maybe 4. What is best option. I do have 2 speakers already-…Continue
I have an excellent running 429 with 400 trans.recently removed from my 64. It has electronic ignition, new water pump,new fan and clutch(not pictured),new fuel pump,Holley 650 vac. sec. carb. with…Continue
So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…