My daily driver '64 Cadillac deVille emitted some white smoke from the engine on start up today and stalled out. Now it will not idle and stalls when I take my foot off of the gas. All of the fluids seem fine, and I have not fiddled with the carburetor anytime recently. It appears that I have a leak from the passenger side valve cover as well. I'll be posting a link to a video as soon as it finishes uploading. Any ideas?
Comment
I agree Russ. All that gunk and grime returning so quickly must be a sign. I'll order the rebuild kit and go pick up some carburetor cleaner tomorrow. I'd like to have this car running top notch.
After putting fresh gas with lead additive, it was running perfectly with no hesitation last night until I had to come to a hard stop at a red light going downhill. Now it's back at it again! It runs fine with my foot on the gas but feels like it is about to stall when it's in gear and stopped.
Good deal! Glad it was something simple. Hard to tell by the short video sound, but it sure sounded like it was popping back through the intake.
Thanks for letting us know what you found.
I did a thorough cleaning on the carburetor tonight and it is idling again, but I need to finish adjusting the air to fuel ratio because I think I can get it running a little better. It has a little suction when I put my hand over it. I'll check out the points tomorrow. This might be a good time to upgrade to an electronic ignition.
I just took this photo today. I last cleaned the carburetor about 3 weeks ago. Tony, I haven't had a tune up in 7 years, but I have not really had any carb trouble up until now. The car has 51,000 (believed original) miles. I can't check the suction on the carb because today it refused to idle unless I was on the gas. The car was driving fine one minute, and the next time I tried to start the car it was barely running. David, I don't have a timing light, but I might be able to borrow one from a friend and use it If I can get the car to idle. Would all this gunk be a clear sign of the carb spitting up? Thanks for all the answers guys.
Sounds like it is spitting back through the carburetor. Have you put a vacuum gauge on it? What is the gauge doing with it idling? Have you ever changed the timing gear and chain? It could have jumped time and the cam is out of time causing it to spit back through the carburetor. Put a timing light on it and see if the timing has changed. If it has, I bet the timing chain has jumped a tooth or two. If not you may have some/a intake valve(s) sticking. At the exhaust pipe outlet, hold your hand close over the opening, does it suck your palm back to the pipe? Sticky/stuck exhaust valve. Do a compression check.
HTH, David
Sorry for the horrible video quality, but this is how it's currently running and the engine stalls every time that I try and give it gas.
Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari 22 hours ago. 3 Replies 0 Likes
for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies 0 Likes
Is anyone here planning on going to the Back to the 50’s car show in Minnesota?
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website