I have a 63 cadillac park avenue.  My bulbs in the door panels in the front driver and passenger sides were out.  I replaced them today and no illumination.   My battery is fully charged and I tried starting the car.  Absolutely no power.  Started fine earlier in teh day.  No lights will come on, no turnover when I start the car--completely dead.  Any ideas as to what the problem might be.   

Views: 178

Reply to This

Replies to This Discussion

Hi Dave,

     Without being there to see it, I would first check both battery cables for proper connections; that the negative is grounded properly to the frame and then the positive cable -especially at the starter/solenoid (that nothing is shorted out).  Also, the ignition switch to see if juice is present when you turn the key.   I would start there and work my way through the wiring.  Without being there it's hard to detect.

Dennis DiBari 

Does the horn or headlight work? Check that the battery posts are clean and tight. Check the starter connections. The red wire comes off of the big post up to the fuse box and to the ignition switch. Check that there is power to the fuse box. Check the connector at the bottom at the red wire to power the fuse box. 

The purple wire on the ignition switch goes to the NSS. Check the large 2 wires on the NSS for continuity when the car is in park. The NSS should connect the 2 large wires together when in park. 

For the lights, check the body feed fuse. 

RSS

Photos

  • Add Photos
  • View All

Forum

Control arm bumper removal

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion 5 hours ago. 0 Replies

While in the middle of my front suspension rebuild, I realized it would be nice to remove the bumpers on the control arms. Does anyone have an easy method for removal? Continue

64 convertible interior lamps

Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Robert Schles 22 hours ago. 2 Replies

Question: Do different interior lamps illuminate depending on whether you open the driver or passenger door? Background: In my '67 DVC, ALL the interior lamps come on when I open either door in the…Continue

Material for making staples for rubber splash shields

Started by Marty Smith in 1963/64 Cadillac Specific Discussion Aug 23. 0 Replies

Here is the link to Mcmaster Carr for Staple material as discussed in the latest Zoom meeting. https://www.mcmaster.com/6517K24/          Not 100…Continue

Blog Posts

Authenticity Manual

Posted by Dennis P. DiBari on August 27, 2026 at 12:45pm 2 Comments

Hi Robert,

     I emailed you more pictures for the Authenticity Manual.

Dennis DiBari

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service