Case Connector O-Ring TH400
Hello All
I have a 64 with the TH400 transmission and I need to replace the o-ring on the electrical case connector due to a small leak. Does anyone know the right size replacement? The o-ring with the red box around it is the one I am trying to figure out the size for and the FSM does not provide details for the O-ring size.
The previous owner used two green (A/C?) O-rings to seal it, plus some type of RTV, and it didn't work.
Any suggestions? Seems like this connector is a 64 only part for the TH400 so I haven't been able to find much online.
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
Give these folks a call.
-
Permalink Reply by Michael Buonaccorso on
-
Thanks Russ, I gave them a call and they had all the parts I needed!
Mike
Members
Forum
Rear suspension project
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion 8 hours ago. 0 Replies 0 Likes
I have started my rear suspension project with the intent to replace bushings on the control links and yoke, shocks, coils and spherical joint. I have the car on jack stands and the transaxle…Continue
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Wednesday. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Chris Codd on Wednesday. 1 Reply 0 Likes
Vintage Promo Picture #4 - 1963 Fleetwood 60 Special in Nevada Silver
Started by Jason Edge in 1963/64 Cadillac Specific Discussion on Wednesday. 0 Replies 0 Likes
Here is the 4th picture in my collection of "Promo Pictures" - another 1963 Fleetwood 60 Special. This 60 Special appears to be Nevada Silver, Paint Code 14. …Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
