Need window switch for 1964 Deville convertible
Of course just the drivers window doesn't work

Views: 282

Reply to This

Replies to This Discussion

Hi Phil, you can often pull the case off the switch body, cleans the contacts and bend tabs up a bit and get working again. Might give that a try if not already done.

the bottom of the switch is broken off and the wires no longer are held in--if is jump the wire out the window goes up and down--been this way for a while finally just quit working

Also check for broken wires inside the door jamb wire conduit.

all the wires have been repaired--99 percent sure its the switch

Maybe I could use a new drivers wiring harness for the window instead. Anyone have one

Phil, the drivers door is always the worst for wear. I have yet to bring in a car with all the wires intact. American Auto Wire builds new wire harness's. You just send them your old one.

I believe I just need the plug at the end where the master switch connects mine fell apart if you have the plug with 6" of wire that would be perfect also the drivers window switch is the only one that is inoperable the other windows all work from the master switch

Phil, I have a plug.  Send me an email to;  russ85747@hotmaiil.com

RSS

Photos

  • Add Photos
  • View All

Forum

64’ A/C Power Servo - Vacuum Actuator

Started by Jacob Foster in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks 23 hours ago. 2 Replies

Gents, good morning!I’m looking for advice on how to fix the A/C Power Servo on my 1964 Cadillac Deville. The unit itself seems to be working correctly, but the vacuum actuator is leaking off. Has…Continue

Transmission and power seats

Started by David Erickson in General Discussion. Last reply by Linda M. Brooks 23 hours ago. 3 Replies

Couple of question on my 63  Park Avenue1.  I had my car worked on last summer by my mechanic who restores casr primarily.  He does not work on transmissions.  He said there was a small transmission…Continue

1964 Cadillac Owners - Are You Missing the Inner Fender to Frame Rear Brace Rods?

Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks yesterday. 7 Replies

Last night I was installing the freshly cad plated inner fender to frame rear support brace rods and remembered how this has been often missing on the many parts cars I have brought in. The thing is…Continue

63 & 64 Eldorados at Mecum Auction in Kissimmee

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Friday. 1 Reply

Here is a 1963 & 1964 Eldorado I saw at Mecum auction in Kissimmee, Florida today.  This was today’s main activity as part of the 2026 CLC Winter Reunion in Orlando. There are over 4,200 event at…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service