Need window switch for 1964 Deville convertible
Of course just the drivers window doesn't work
Facebook Facebook

Views: 266

Reply to This

Replies to This Discussion

Hi Phil, you can often pull the case off the switch body, cleans the contacts and bend tabs up a bit and get working again. Might give that a try if not already done.

the bottom of the switch is broken off and the wires no longer are held in--if is jump the wire out the window goes up and down--been this way for a while finally just quit working

Also check for broken wires inside the door jamb wire conduit.

all the wires have been repaired--99 percent sure its the switch

Maybe I could use a new drivers wiring harness for the window instead. Anyone have one

Phil, the drivers door is always the worst for wear. I have yet to bring in a car with all the wires intact. American Auto Wire builds new wire harness's. You just send them your old one.

I believe I just need the plug at the end where the master switch connects mine fell apart if you have the plug with 6" of wire that would be perfect also the drivers window switch is the only one that is inoperable the other windows all work from the master switch

Phil, I have a plug.  Send me an email to;  russ85747@hotmaiil.com

RSS

Photos

  • Add Photos
  • View All

Forum

Power steering fluid

Started by Bobby Brown in General Discussion. Last reply by Dennis P. DiBari 4 hours ago. 6 Replies

My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue

1963 AC evaporator core leaking?

Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton 23 hours ago. 2 Replies

Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue

Tags: 1963, core, evaporator, AC

seat foam replacement

Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Kevin Robles yesterday. 3 Replies

does anyone out there have any experience with seat foam replacement on  a 63/64 Cadillac.  I had my seats reupolstered  many years ago in original leather/fabric and they still look great, but the…Continue

1963 carter afb carbureter stainless steel shim

Started by tim sparks in General Discussion on Tuesday. 0 Replies

anybody have an xtra stainless steel shim for 1963 carter afb carb. thank youContinue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service