I have had this info written up for some time and meant to post so here it is. I will link to this from our Help Page:
1963/64 Cadillac Starting - Cranking System Basics
Wiring
You have a positive cable from battery to the large bolt on the starter solenoid, a yellow wire from the (R) side of starter solenoid switch to the ignition coil, and a dark blue wire from the (S) side of solenoid to the Neutral Safety Switch, which in turn is fed by the purple(violet) wire from the ignition switch. There is a large ground strap from right frame rail to transmission bell housing bolt to engine block. The frame is grounded directly by the negative battery cable which attached to the frame on the right side just in front of the radiator support under the battery tray.
The Neutral Safety Switch Prevents Cranking in “Drive” Gears
The blue and purple cranking circuit is closed when the shift selector is in Park or Neutral, and open in any drive gear in order to prevent cranking the car in gear.
Starting - Cranking
With ignition switch turned to far right cranking position, the purple wire feeds the 12 volts to the blue wire at the neutral safety switch which feeds the starter solenoid switch. The yellow wire from solenoid switch in turn provides a full 12 volts back to the ignition coil for cranking. When you release the switch and have the switch in "run" position, the voltage to the coil is reduced to 8 1/2 to 10 1/2 volts since current is then provided through the brown resister wire, which gets it's current at the pink ignition wire under the dash. On the solenoid switch, the outer terminal away from engine is marked R and has the yellow wire connected. The inner wire is marked S and has the blue wire connected. The yellow wire is often dirty and hard to see the color and requires some cleaning.
Cranking Problems
One of the most important and overlooked components in the cranking circuit is the large ground strap that runs from the right frame rail over to the large bolt through transmission bell housing to engine and starter. If this is not connected and making good connection your starter will not work. Check your ground strap and make sure it is making good connection. If all other wiring is connected correctly, you could also have a bad ignition switch or melted and shorted ignition switch connector. Remove lower dash panel and disconnect the ignition switch connector and inspect closely with a light looking for melting and shorting. If all looks good, you can bypass the ignition switch and hot wire the car as noted below.
Hot Wiring
You can disconnect the large connector on the back of the ignition switch and hot wire the car by connecting the red (battery) to pink (ignition) wire and touching to Purple (starter). I had a switch go bad on the way to a car show a few years back and made a quick 3 way jumper to hot wire the car. Here is a video showing how simple it is: https://6364cadillac.ning.com/video/hot-wired-ignition-switches
Bypassing the Neutral Safety Switch is Easy
It is just a matter of unplugging the connector with the purple and dark blue wire and jumping the connector. Be aware the car will no crank I any gear.
Tags:
Bumping this up since we have had some newer questions about ignition and cranking wiring.
Travis J. Hensley Online
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal on Friday. 2 Replies 0 Likes
So I have been having problems with my brake lights. At first I thought it was both sides and turns out it is only the drivers side. Also, I thought the blinker worked and it didn’t and turned out…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 11 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Started by Nile Bolen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari Jul 21. 4 Replies 0 Likes
I checked the Help page and did a search on the site but didn't see any subjects on steering play/slack. Since I had someone complete a front end rebuild (Kanter kit, all the control arm bushings,…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler Jul 21. 12 Replies 0 Likes
Late in the evenings, I wonder about things I will probably never do as I am not that crazy. However, I know someone out there has tried it or wanted it bad enough they have done it. My 64 Fltwd did…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by