Hi All,

    I finished my 429 transplant (Still a 429) last fall and cannot get the car to run correctly.  The carburetor, a stock Rochester 4gc was fully dismantled and cleaned and put back together.  car starts and roughly idles but when you put in drive it runs all over itself and will sometimes dies.  Then we get to when it get to operating temp and stalls and will not restart until it cools down.  It will crank over and start on fuel directly in throat of carb, but seems to be starved for fuel otherwise.  

This is an AC car and the Motor swap was from a 64 with AC.

The Fuel filter housing has the vent back to the tank and the tank was replaced with the proper vent return accommodations. I guess I will check that the filter housing is not plugged but not a 100% if its actually Vapor Locking or not? 

I'll be the first to tell you that I am not the greatest at tuning up a vehicle, but any help or direction setting up the carb and other adjustments to fix this condition would be greatly appreciated.

Thanks, 

Joel

Views: 52

Reply to This

Replies to This Discussion

Hi Joel,

     Do you know how your gasoline is - condition wise?  Do you have water in the gas?  When it runs all over itself, it could be bad gas or dirt in the line.  A clogged needle and seat might also cause some of the conditions you described.

Dennis DiBari, NY

Hi Joel, how sure are you of the condition of the fuel pump?

I had a pump go out on me and I thought I was fighting vapor lock.

I do have a new fuel pump I can throw on. Thx will give that a try

Joel,

     I also sent you a message - check that as well.

Dennis DiBari

RSS

Photos

  • Add Photos
  • View All

Forum

For Sale - Fresh Chrome 1963 Series 62 Conv/CDV/Eldorado door panel chrome bezels

Started by Anthony Vanacore in For Sale. Last reply by Anthony Vanacore on Wednesday. 5 Replies

Hello,My father and I are restoring our 63 series 62 conv, we had the chrome bezels for the window/seat switches rechromed.  During this process we also installed factory power door locks to the…Continue

No AC 1963 Eldorado Unique Dash End Panels

Started by Jason Edge in General Discussion May 3. 0 Replies

As I was documenting the non-AC 63 Eldorado parts car I bought in a couple months ago, the solid panel dash end panels intrigued me and thought I would share a couple of pictures and thoughts. First,…Continue

WTB 63 Series 62 Original Trunk Material

Started by Anthony Vanacore in Wanted to Buy. Last reply by Russ Austin May 1. 1 Reply

Hello,I am looking for an original trunk for a series 62 convertible.  Condition does not need to be perfect and does not need to be complete, I am looking for a set that I can use as a template. I…Continue

Parts to replace Power Brake and Master Cylinder for 1964 Eldorado

Started by Remco Waller in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari Apr 27. 1 Reply

I have a 1964 Eldorado and based on paperwork received with the purchase the Power Brake unit & master Cylinder were never replaced. The brakes are working currently well but as pre-caution I…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service