Yaw mounts

Hi Everyone

Does anyone know where I can get a set of new or good condition used Yaw mounts? I am located in South Australia Thanks

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by 3ft7bqmb7dryo on October 8, 2023 at 9:20am

I have used yaw mounts, but I need to know what year and trans is i the car. <y email is russ@thecadishack.com

▶ Reply

Permalink Reply by Phillip Hill on October 9, 2023 at 4:18am

Hi Russ
Thanks for reaching out i have a 63 deville with hydra matic trans

the current Yaw mounts I have don’t have any rubber on them if you could advise me on a cost that would help

Could you take a look at the attached pic and tell me if the cross bar has been altered.i believe there has been a plate welded to the base or is this a standard part?

thanks again

Attachments:

IMG_0254.jpeg, 4.6 MB

▶ Reply

Permalink Reply by 3ft7bqmb7dryo on October 9, 2023 at 9:07am

I believe that the convertible models did that for strength. I generally don't quote prices on line in forums because that is our business to discuss off line.

Send me and email and we can continue the conversation. russ@thecadishack.com

▶ Reply

RSS

Welcome to
63/64 Cadillac Website

Sign Up
or Sign In

Or sign in with:

Photos

Forum

Burning Rubber

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 2 hours ago. 6 Replies 1 Like

Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue

Gas gauge only reads half when full

Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes

Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue

64 Brakes

Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes

Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue

Heater Core Replacement

Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson Feb 15. 6 Replies 0 Likes

I'm currently rounding up parts for a heater core replacement in my 1964 Deville. I'm looking for replacement hoses that connect to the heater core itself. It's a factory a/c car and has the metal…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments 0 Likes

Continue

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?