Well, it looks like my seat motor decided to give up. Armature turns free, brushes are fine but no go.

Anyone out there have one. Thanks tbbahner@embarqmail.com

Tom B

Views: 193

Facebook Facebook

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on February 19, 2014 at 7:03am

You can see illustrations of this from our Help Topics page under Seat Pictures and Illustrations:

Seat and Seatbelt Illustrations and Pictures
http://6364cadillac.ning.com/photo/albums/misc-seat-and-seat-belt-illustrations-and-pictures

Here is a copy of the picture testing the 6-way bench seat motor:

6 way motor testing

For those with the 2 way seat motors it is a more direct test method as you attach ground to body, and 12+ to each of the two contacts in the connector. One contact will turn forward and eon will turn backwards:

2 way motor

Comment by Tom Bahner on February 18, 2014 at 9:50pm

Yeah, disassembled and cleaned up, armature/shaft turns free, brushes are fine.

Grounded motor housing and put 12v to green and yellow wires, no body home.,

Photos

  • Add Photos
  • View All

Forum

Brake Booster not enough compression

Started by Rick Yasenchack in 1963/64 Cadillac Specific Discussion. Last reply by Rick Yasenchack 5 hours ago. 4 Replies

I bought my 63 2-door convertible 62 series a few years back, previous owner said a new brake booster was just installed and that was why brake pedal was a rock.  Did not know.Just had engine…Continue

For sale; Hydra Matic transmission

Started by Russ Austin in General Discussion yesterday. 0 Replies

Known good Hydra Matic transmission for a 63 64 Cadi.Came out of my driving 63 coupe. I went the LS route.Resealed the pan, speedo drive, front and rear seals.Comes with a new rear…Continue

Houston we have a problem!

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Thursday. 5 Replies

While enjoying the fruits of my labor on all new rear suspension and…Continue

Commercial Chassis Dual Battery Tray Questions

Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Tuesday. 2 Replies

I'm looking for some info and hopefully some pictures on the commercial chassis dual battery setup.  Is the second battery tray (driver side) , the same as the passenger side or is it mirrored?  I'm…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service