need passenger side manifold any ideas?

Views: 146

Facebook Facebook

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Michael Anderson on May 12, 2015 at 8:02pm

Thanks for checking,I think I resolved my situation with some old fashion enginuity

Comment by William Cameron on May 12, 2015 at 7:40pm

Michael, I only have the drivers side (for the 429) and passenger side for the 390 (which happened to be on a 64, 429. they just modified the exhaust system)  sold all the 429 passenger side manifolds. sorry

Comment by Michael Anderson on May 12, 2015 at 4:35pm

thanks William appreciate you

Comment by William Cameron on May 11, 2015 at 10:31pm

I know I have a passenger side ex manifold for the 390, I'll check tomorrow see if I have one for the 64' 429

Comment by Michael Anderson on May 11, 2015 at 5:22pm

64 429 cid

Comment by Jason Edge on May 11, 2015 at 4:39pm

What Year? I am out of both the 63 and 64 styles but can put you on my Wait List if no one else has one.

Photos

  • Add Photos
  • View All

Forum

Replace Choke Tube or Install Electric Choke?

Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Stinson 2 hours ago. 7 Replies

My mechanic has sourced a choke housing and new internals.  As you might expect, the choke tube is damaged and or clogged.  My options are to either replace the choke tube, or my mechanic recommends…Continue

Tags: Electric Choke, Choke Tube

TH400 Dipstick Tube Seal

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Buonaccorso 10 hours ago. 10 Replies

In my “rebuild” of the transmission, I ordered a dipstick tube seal. However, I’m not sure if the right one came or how to best install the seal. I am wondering if anyone has replaced this seal OR…Continue

window regulators

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Saturday. 2 Replies

For years my winds have seemed to be looser and less accurate than most modern windows.  I am thinking the soft parts are worn.  Has anybody gone through thier window regulators and felts to restore…Continue

Correct whitewalls

Started by Richard Stanley in 1963/64 Cadillac Specific Discussion on Thursday. 0 Replies

 I just replaced my tires from Diamondback (I had bad results in the past from Coker).  It was the second time, due to the age of the tires.  About 18 years ago Diamondback made custom whitewalls…Continue

Tags: width, whitewall, correct

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 0 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service