Traveling to Orlando, FL Area Sept 27 for Anyone Needing Large Parts Delivered

On Thursday, Sept 27 I will be heading down I-95 through NC, SC, and Florida, and across I-4 past Orlando to Winter Haven to pick up a a 63 Coupe Deville Parts car.  The plan is to return on Saturday Sept 29.

As most of you that have dealt with me know, I usually do not deliver large parts and its up to you to "come and get" or to arrange with a shipper.

If you need a hood, windshield, doors, transmission, engine, are other large, heavy items I will have an open car hauler on the way down and can meet up with anyone near I-95 or I-40.  Both the hood and trunk lid off the 64 convertible I'm parting out is absolutely nice and still available. I've got at least a dozen Turbo Hydrmatics at $150 a pop, that were running/driving when removed and a couple of 3.21 standard rear ends.  If you need front suspension items I've got a ton of that stuff not to mention literally thousands of parts from 38 parts cars.

If you need something and are somewhere along the way between Raleigh, NC area and Orlando Florida give me a shout at jasonedge@nc.rr.com

Views: 90

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on September 26, 2012 at 7:14am

Will be packing up after work today and heading down to Winter Haven FL for 63 CDV early tomorrow morning. It's a looong drive but might as well put the Car Hauler to use once in a while!  Anyone on the I-95 & I-4 route that needs say a windshield, engine block, TH transmission, etc, here's a slipping change for delivery...at least to an I-95 or I-4 exit!

Comment by Jason Edge on September 22, 2012 at 11:43am

Bumping this up for anyone along the I-95 & I-4 route to FL.

Comment by Jason Edge on September 18, 2012 at 1:54pm

Hopefully after I retire from the State I can do more cross country trips and make it to more areas of the country and more often. Having a full time job prevents me from making many long trips like this!

Photos

  • Add Photos
  • View All

Forum

Power Booster Install

Started by Rob Spring in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies

Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue

Complete Front End Rebuild

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata yesterday. 1 Reply

I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue

1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly

Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Wednesday. 1 Reply

Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering.  Also, possibly looking for an oil filter housing assembly for a 1964 429 motor.  Starting to get…Continue

A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies

As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 13 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service