Does anyone have a pic of where the approximate location should be for the differential decal inside the trunk ? There is a pic In one of Jason's posts but it is a close up and not too definitive Thanks !
Tags:
Marty I added better pictures on the Rear End/Differential thread at this link: http://6364cadillac.ning.com/profiles/blogs/differentials
Note, That I have pictures of 3 1964's with the Controlled and they are in the same location as posted in the link and on my car. I did find a 63 with limited slip and it was in the same relative location, but on the left side, so perhaps 63's was on the LH side. I know even on the 64's they are in the same relative spot but have seen them up or down an inch or two. Either way no one would knock any points off at GN judging regardless or side. I will dig around my parts car pictures some more.
Thanks Jason , I wasn't that concerned abut the judging points I was more concerned of you seeing it in the wrong place and asking why I didn't ask you where it went : ).
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf 1 hour ago. 1 Reply 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth 23 hours ago. 15 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge on Thursday. 6 Replies 0 Likes
First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system. The old system was very good, however, I believe what Bill and the…Continue
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Tuesday. 3 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by