Marty Smith's Discussions (23)

Discussions Replied To (21) Replies Latest Activity

"  New preformed lines available at Inline tube . https://www.inlinetube.com/products…"

Marty Smith replied Nov 6 to Dino's Gas Lines Removed - Clean Up or Replace --> Member Advice

11 6 hours ago
Reply by Jason Edge

"Kevin, you are correct mid 80's is way off from your description and its issues, I a…"

Marty Smith replied Nov 5 to Possible ‘64 Eldorado Purchase

9 Nov 5
Reply by Jason Edge

"  Kevin, we need a little more info, what is an outrageous price to some might be ch…"

Marty Smith replied Nov 5 to Possible ‘64 Eldorado Purchase

9 Nov 5
Reply by Jason Edge

"  Rock Auto has a SKF seal  and a speedy sleeve kit as well. "

Marty Smith replied May 6 to Replacement Front Crankshaft Seal - 1964 Eldorado (429ci)

2 May 7
Reply by Jason Edge

"Logan , if you take off the wheel cylinder and remove the dust boot a Tape measure w…"

Marty Smith replied Mar 18 to Brake wheel cylinder bore

9 Mar 19
Reply by SK

"My 2 cents to this after agreeing with Dennis and Jason is to make sure that the are…"

Marty Smith replied Oct 4, 2024 to Trans Pan Seal Replacement

11 Oct 25, 2024
Reply by Dennis P. DiBari

" I have a set in my 60 coupe , I had a set in the 64 Eldo I sold I had them in when…"

Marty Smith replied May 10, 2024 to T3 Headlights

3 May 11, 2024
Reply by Jeff Donaldson

" When you say "boot" are we talking about the cover that goes over the top when it i…"

Marty Smith replied Mar 26, 2024 to BOOT

1 Mar 26, 2024
Reply by Marty Smith

" Jeff , if you look in the help section Jason did a write up about the Battery and B…"

Marty Smith replied Jan 22, 2024 to Need Spring Ring pos battery cable for 64

3 Jan 28, 2024
Reply by Jason Edge

"     I saw the title on my giude and recorded it, the car was definitely the star of…"

Marty Smith replied Nov 20, 2020 to Check out Chapter Member Larry Rees' 1964 de Ville Convertible in "Christmas on Wheels" Movie

2 Nov 20, 2020
Reply by Jason Edge

RSS

Photos

  • Add Photos
  • View All

Forum

Rear Upper trailing arm, Rear ball joint, Rear lower trailing arms

Started by Norman Silverman in 1963/64 Cadillac Specific Discussion. Last reply by Norman Silverman 2 hours ago. 4 Replies

Has anyone replaced any/all of these parts? If so, where did you buy them? Also, and most importantly, did replacing them change any characteristic of the car, like maybe reduce driveline…Continue

Dino's Gas Lines Removed - Clean Up or Replace --> Member Advice

Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge 6 hours ago. 11 Replies

As part of my undercarriage cleanup and and restoration of my 64 Coupe de Ville 'Dino', I removed both gas lines (my car has AC so it has a 5/16" supply line and 1/4" vent return line) to gain better…Continue

1963/64 Cadillac Starting - Cranking System Basics

Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Chris McBride 7 hours ago. 17 Replies

I have had this info written up for some time and meant to post so here it is. I will link to this from our Help Page:1963/64 Cadillac Starting - Cranking System Basics Wiring You have a positive…Continue

Free cylinder heads and diffential in Phoenix metropolitan area

Started by Chris McBride in 1963/64 Cadillac Specific Discussion 7 hours ago. 0 Replies

Cleaning the shed - free partsI have no interest in shipping.Parts are located in Phoenix metropolitan area. Zip code is 85257. Nearest major intersections are Thomas Road and Scottsdale Road.Two…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service