Hi There- I am in Ontario Canada so the prices wont be exactly the same as the USA- but I still have a pricing question. I have another Cadillac guy bugging me for my 1964 Headlight buckets and vacume canister. I need to know what they are worth as I don't want to over charge him or ask too little. They are off a very low mile car with no damage- only chipped paint.

Facebook Facebook

Views: 91

Reply to This

Replies to This Discussion

100 for everything sèems fair enough. To get that stuff shipped to his door would probably be a bit more. 

I sell the 64 vacuum canisters with tested check valve for $50, and the fender extensions/headlight housings in from $50 to $75 each depending on condition. I usually remove that inner trim piece that book ends the upper grill and sell it separate unless the person needs it. When someone buys multiple items I will usually knock some off the price.  I show the headlight housings as about 5lb each so for shipping you can expect 12 lb for all three pieces.  You also need to consider box size. For US Postal anything over 84" length + girth is considered a "Large" package but you should be able to get these in a box considerable smaller than that. 

RSS

Photos

  • Add Photos
  • View All

Forum

seat foam replacement

Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Kevin Robles 15 hours ago. 3 Replies

does anyone out there have any experience with seat foam replacement on  a 63/64 Cadillac.  I had my seats reupolstered  many years ago in original leather/fabric and they still look great, but the…Continue

1963 carter afb carbureter stainless steel shim

Started by tim sparks in General Discussion 21 hours ago. 0 Replies

anybody have an xtra stainless steel shim for 1963 carter afb carb. thank youContinue

Timing cover corrosion

Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 1 Reply

Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump  Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue

Convertible bumper jack

Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark yesterday. 13 Replies

My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk.  Anyone have a picture of the item I should find?Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service