63/64 Convertible interior quarter rub guard
Wanted: interior rub guard for a convertible. Attaches to the rear-most edge of the quarter trim panel. It's a small stainless piece with one screw attaching it. See photo. Need the right (pass) side.
Replies to This Discussion
-
Permalink Reply by Michael Forte on
-
Bumping this. The last piece I need to complete my interior restoration. Attaches to the rear-most edge of the rear quarter trim panel. It's a small stainless piece with one screw attaching it. I only need the passenger side but will buy both if you have them. I've seen them on Old's and Pontiac convertibles as well. Should be the same for 63 and 64.
-
Permalink Reply by 3ft7bqmb7dryo on
-
Have you contacted willigton Cadillac? He has a 63 convert parts car.
-
-
These are either extremely rare or I just don't know where to look. But....After more than 5 years of looking I finally found a set from a 1963 Pontiac P8 on ebay and scooped them up.
-
-
It really was a happy moment. I can now say that my interior restoration is 100% complete!. Done!
Now, on to restoring the engine compartment....
-
Permalink Reply by Jason Edge on
-
Congrats on the find!
Photos
Members
Forum
64 Deville Fuel Tank Sending Unit
Started by Jeff Tepper in Restoration Discussion 41 minutes ago. 0 Replies 0 Likes
HI all,I replaced my sending unit with a no name one off ebay and it is all over the place. It does not even attempt to have any accuracy.We may try to fix the original unit. Seems like we need to…Continue
Removing Wiper Motor
Started by Karl Schwarz in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 3 hours ago. 1 Reply 0 Likes
I have a 1963 Model 62 convertible. I am trying to remove my wiper motor to replace its relay that is sticking. I got the shroud top ventilator frame off using the directions in the Shop Manual (note…Continue
63 Cadillac no electrical power
Started by David Erickson in General Discussion. Last reply by Russ Austin 7 hours ago. 2 Replies 0 Likes
I have a 63 cadillac park avenue. My bulbs in the door panels in the front driver and passenger sides were out. I replaced them today and no illumination. My battery is fully charged and I tried…Continue
DIDGAKNOWTHAT? - Notches for Holding License Plate Door Open when "Filling Up!"
Started by Jason Edge in General Discussion. Last reply by Jason Edge yesterday. 3 Replies 0 Likes
I casually mentioned during our Zoom meeting Sunday that there are notches for using the gas cap to hold the license plate door open while filling up and a couple of members indicated they did not…Continue
Blog Posts
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Vintage Air AC
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 1 Like
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
accumulator dryer
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
Events
-
December 15, 2024 - 63/64 Cadillac Chapter Zoom Meet-Up
December 15, 2024 from 7pm to 8:30pm – Zoom
0 Comments 0 Likes
Videos
© 2024 Created by Jason Edge.
Powered by
