Neither of my cornering lights are working. I started by focusing on drivers side. I removed the entire assembly and cleaned it up, replaced the wire to the socket, cleaned and lubricated the socket and spring. Made sure light now worked by attaching directly to battery terminals. Reinstalled assembly and plugged it back in and no work. Attached a separate ground directly to the battery terminal and still no work. I checked orange power wire coming in and no power. I have the ignition turned on, signal on, headlights on and still no power to orange wire. Everything working but the corner light. Passenger side does not work either but have not done anything on that side yet. Figure one side at a time. Where should I look next. I have a manual. Thanks Larry

Views: 731

Reply to This

Replies to This Discussion

Ok I got the switch out and the green wire was broken at the plastic clamp. It was tricky to manoeuvre and wondered if I was missing an easier way out. Thanks for the help. I took out the steering column clamp mid way down but the steering column only came down about an inch. Is there something I am missing to get it down further or is that it. Going to be tough getting little bolts and screws back in on those cover plates.

Thats all you will get with just the top clamp removed. There is a bottom clam as well. Be farefull to not damage the steering rag joint. 

Loosened off the two bottom bolts at steering column base clamp and the two bottom floor bolt which dropped column enough to get the job done. Once again thanks to all for the tips and guidance. Larry

Congrats on the fix! ps. I have been staring at an outer T-3 headlamp on that last parts car still up on the car hauler. If it works and you still need one it has your name on it.

If he doesn't want it, I would be interested.

Tony, Larry had been waiting a long time for  good outer T3 and was next up on the Wait List. I have one other Chapter member on the list after Larry, so you would be #2 in line after Larry gets this one. I assume you need one outer T3.
I do  have 6 tested inner Hi Beam T3's for you or anyone that needs that T3 headlamp.

Thank you Jason. I ended up ordering one from Russ.

That is great. They are getting harder and harder to find. If anyone else needs the inner hi beams I have 6 and they are $15 each for Chapter Members.

I’m going to take it. We ended up talking outside the site

RSS

Photos

  • Add Photos
  • View All

Forum

1963 Cadillac Fleetwood 60 Special Eyebrow Molding

Started by Stephen Pechenik in Restoration Discussion. Last reply by Linda M. Brooks 12 hours ago. 3 Replies

I am readying my Fleetwood to be painted.  I need to replace the driver's side left chrome eyebrow molding (below the headlights).  It appears to be made from pot metal.  Mine is broken and I need to…Continue

Tissue holder

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion on Sunday. 0 Replies

Hi everyone I would like to know dose anybody here have a tissue holder fitted to their car if so could you please send me a picture of it thanks in advance Continue

CLC Membership Dues Go Up April 1st - Renew Now Thru March 31 & Lock in Current Rates!

Started by Jason Edge in 1963/64 Cadillac Specific Discussion on Saturday. 0 Replies

CLC Membership dues are going up April 1. Join or Renew between now and March 31 and save! You can even renew with current rates for up to 3 years!Here is a breakdown of the rate increases Effective…Continue

Tags: Increase, Dues, CLC

CLC Membership dues are going up April 1. Join or Renew before March 31 & Save!

Started by Jason Edge in Chapter Discussion on Friday. 0 Replies

Here is a breakdown of the rate increases Effective April 1:E-membership…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service