I am not having issues with with my vacuum unit but have been looking at what it would take to replace it if became necessary. Can the 2 nuts that hold it to the rear plenum be reached from the inside without removing the plenum? The rear plenum is very close to the firewall and it appears that space is quite limited to access the nuts on the backside of the plenum.
Tags:
I did mine working from inside with the glove box liner removed. Posted here https://6364cadillac.ning.com/forum/topics/recirculation-actuator-r...
The vacuum unit you are showing has already been replaced. The unit I am speaking about controls the flow of air between the floor/ac ducts. It is mounted inside the rear half of the heat/ac assembly and the retaining nuts are facing the firewall.
Started by David Michael Bigeleisen in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
Dear Cadillac friends:I have a 1963 Fleetwood.The transmission dipstick has bubbles in it when I check the fluid.Also, the transmission shudders when I drive up a slight incline in reverse.I had the…Continue
Started by Jason Edge in Chapter Discussion. Last reply by Jason Edge on Tuesday. 1 Reply 0 Likes
Here is a breakdown of the rate increases Effective April 1:E-membership…Continue
Started by Jason Edge in Newsletters on Tuesday. 0 Replies 0 Likes
Here is another sneak peak of our next newsletter feature - Denis Binette's 14K mile 1964 Coupe de Ville. I hope to have this distributed within the next couple of weeks. …Continue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by CHRIS CARLSON Feb 27. 1 Reply 0 Likes
Hey everyone, I need to replace my transmission input seal before spring starts, I’ve been losing a lot of fluid post Sunday drive. I figured I’d do the rear main seal service bulletin at the same…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by