64 Convertible Parts
Hello
Does anyone know who would have a
1) "Top Boot Slide Rail" for my convertible top boot.
2) Driver side solid Fender Trim
I asked Jason and Russ and neither one has one. Any help would be appreciated.
Thanks
Dominic
Replies to This Discussion
-
Permalink Reply by Dennis P. DiBari on
-
Hi Dominic,
I just replaced my passenger side fender trim. Mine is 65 3/4" long; it's a 1964 Series 62. I searched everywhere for a year and finally got it from CPR (Cadillac Parts and Restoration). He is great and runs the CLC 59-60 Chapter. He is in Poughkeepsie, NY. His name is Frank Nicodemus. Even got the clips from him. He'll remember me, as he did some work on my steering column/horn.
Dennis DiBari, Cottekill, NY
Your convertible is great!
-
Permalink Reply by Dominic Salemi on
-
Dennis
Thank you and I also found one on JEGS but not sure it is the correct part. The picture shows correct part but you know how that could go.
Thank you
Dominic
-
-
OK Dom. Keep CPR as a good resource, being you are also in NY.
Dennis
Members
Forum
Power Booster Install
Started by Rob Spring in 1963/64 Cadillac Specific Discussion. Last reply by Rob Spring on Tuesday. 9 Replies 0 Likes
Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue
1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly
Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Monday. 3 Replies 1 Like
Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering. Also, possibly looking for an oil filter housing assembly for a 1964 429 motor. Starting to get…Continue
Complete Front End Rebuild
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata Apr 3. 1 Reply 0 Likes
I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue
A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari Apr 2. 2 Replies 0 Likes
As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 13 Comments 0 Likes
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
