63/64 Cadillac Website

64 Convertible Parts

Hello

Does anyone know who would have a

1) "Top Boot Slide Rail" for my convertible top boot.

2) Driver side solid Fender Trim

I asked Jason and Russ and neither one has one. Any help would be appreciated.

Thanks

Dominic

0 members like this

Facebook Facebook

▶ Reply to This

Replies to This Discussion

Permalink Reply by Dennis P. DiBari on October 1, 2024 at 7:13am

Hi Dominic,

I just replaced my passenger side fender trim. Mine is 65 3/4" long; it's a 1964 Series 62. I searched everywhere for a year and finally got it from CPR (Cadillac Parts and Restoration). He is great and runs the CLC 59-60 Chapter. He is in Poughkeepsie, NY. His name is Frank Nicodemus. Even got the clips from him. He'll remember me, as he did some work on my steering column/horn.

Dennis DiBari, Cottekill, NY

Your convertible is great!

▶ Reply

Permalink Reply by Dominic Salemi on October 1, 2024 at 7:51am

Dennis

Thank you and I also found one on JEGS but not sure it is the correct part. The picture shows correct part but you know how that could go.

Thank you

Dominic

▶ Reply

Permalink Reply by Dennis P. DiBari on October 1, 2024 at 8:13am

OK Dom. Keep CPR as a good resource, being you are also in NY.

Dennis

▶ Reply

RSS

Welcome to
63/64 Cadillac Website

Sign Up
or Sign In

Or sign in with:

Photos

Forum

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion 13 hours ago. 0 Replies 0 Likes

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 2 Replies 0 Likes

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth on Saturday. 15 Replies 4 Likes

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Future of CLC Judging

Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge on Thursday. 6 Replies 0 Likes

First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system. The old system was very good, however, I believe what Bill and the…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue