I’m looking for the small passenger side C-pillar trim piece (roughly the division between roof and body) for my 63 Sedan de Ville. 
This is not the wide molding that extends sideways from the rear window, but a narrow trim piece right below that!

Anyone here?

Views: 110

▶ Reply to This

Replies to This Discussion

I believe you have a 63-6339 body style (1963 4 Window Sedan de Ville)

If this is the rear qtr belt or drip molding I would have.

Here is link to rear qtr molding: https://www.facebook.com/media/set/?set=a.588387922743195&type=3

Here is link to drip molding: https://www.facebook.com/media/set/?set=a.626886205560033&type=3

If it is another trim  piece I would probably have and either a picture or shop manual name & reference would help. Email me details at jasonedge64@outlook.com

Hi Jason,

I’m looking for a small stainless trim piece, right below the wider molding (see pic).

Looking at your 1963 Shop Manual page 16-76, Item H - Roof Panel Side Rear Molding, That trim goes parallel with the bottom edge of the car body C pillar and extends over the rear section of the door. That rear section of the door is painted at top. Perhaps you are dealing with early production flat trim added to the doors??? 

I do have plenty of the Roof Panel Side Rearm Molding trim pieces some in very nice condition.

Perhaps you can provide a picture of this trim piece removed from right side, or still attached to left side. Other than that I am completely at a loss.

RSS

Photos

  • Add Photos
  • View All

Forum

lower rear control arm bushings on a 1964 Sedan de Ville

Started by Ron Perry in 1963/64 Cadillac Specific Discussion. Last reply by Robert Alan Shannon 11 hours ago. 3 Replies

Hello I am installing new bushings on my lower control and upper yoke arms. Does anyone have any advise or things I should be aware of in removing and installing the new bushings. Thankyou Ron PerryContinue

1964 Cadillac DeVille for Sale

Started by Jason Meyer in For Sale on Wednesday. 0 Replies

Hey everybody, I have a family owned since new 64 Cadillac model 6267 Deville Convertible I have to part with. It runs strong with a 429 V8 original engine with 90,000 miles on it. Suspension has…Continue

Tags: 1964, Convertible, Original

Take heads off for rebuild

Started by Ian Arnold in 1963/64 Cadillac Specific Discussion. Last reply by Kurt Oct 3. 13 Replies

Compression test 15 years ago was good. Not a lot of miles since then. Summer car.Last year had a oil pressure issue. Found an aluminum flake had stuck open oil pressure relief valve. (Low pressure…Continue

1963 Dashboard With Autronic Eye Hole

Started by Earl R in For Sale. Last reply by Earl R Oct 2. 4 Replies

I bought this from a yard in Washington state.  I was told it was pulled and kept inside as soon as the car came in. I was going to dye and install it in my '63 Eldorado but sold the car.  Please see…Continue

Tags: Dash

Blog Posts

Authenticity Manual

Posted by Dennis P. DiBari on August 27, 2026 at 12:45pm 2 Comments

Hi Robert,

     I emailed you more pictures for the Authenticity Manual.

Dennis DiBari

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service