I’m looking for the small passenger side C-pillar trim piece (roughly the division between roof and body) for my 63 Sedan de Ville. 
This is not the wide molding that extends sideways from the rear window, but a narrow trim piece right below that!

Anyone here?

Views: 73

Reply to This

Replies to This Discussion

I believe you have a 63-6339 body style (1963 4 Window Sedan de Ville)

If this is the rear qtr belt or drip molding I would have.

Here is link to rear qtr molding: https://www.facebook.com/media/set/?set=a.588387922743195&type=3

Here is link to drip molding: https://www.facebook.com/media/set/?set=a.626886205560033&type=3

If it is another trim  piece I would probably have and either a picture or shop manual name & reference would help. Email me details at jasonedge64@outlook.com

Hi Jason,

I’m looking for a small stainless trim piece, right below the wider molding (see pic).

Looking at your 1963 Shop Manual page 16-76, Item H - Roof Panel Side Rear Molding, That trim goes parallel with the bottom edge of the car body C pillar and extends over the rear section of the door. That rear section of the door is painted at top. Perhaps you are dealing with early production flat trim added to the doors??? 

I do have plenty of the Roof Panel Side Rearm Molding trim pieces some in very nice condition.

Perhaps you can provide a picture of this trim piece removed from right side, or still attached to left side. Other than that I am completely at a loss.

RSS

Photos

  • Add Photos
  • View All

Forum

Clock Repair

Started by Michael Vogler in General Discussion. Last reply by Dennis P. DiBari on Sunday. 6 Replies

63/63 Owners,The clock in my '64 just went out. It appears that the mechanical component is working properly, so I think the coil has failed. I contacted Jerry at Clockworks and he advised that he…Continue

No dash lights, headlights only come on with dimmer

Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton on Sunday. 6 Replies

I’m in the midst of refreshing some things in my dash. I got my passenger ash tray working for the first time ever apparently, evident by the factory defect tag. “While I’m in here I might as well…Continue

Burning Rubber

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler on Sunday. 14 Replies

Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light?   Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue

Down and Out for a Couple of Weeks --> but On the Mend

Started by Jason Edge in General Discussion. Last reply by Michael Vogler on Sunday. 3 Replies

I have been more than a bit quiet the past couple of weeks due to a really bad fall January 31 where I tore my right knee MCL ligament and ruptured the ACL Ligament. MCL will heal in time but ACL is…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service