Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.
However after installing and filling it up, it only reads half full after filling the tank up.
Is there a way to calibrate this? Does it involve bending the float arm? I'd hate to drop the tank again.
I've searched the forum high and low for this issue and haven't been able to find anything - just some dead links when referring to gas gauge calibration in this thread.
Thanks in advance!
Tags:
The gauge is out of calibration. I have gas gauges that I had calibrated at an electrical shop for 125.00
email me at russ@thecadishack.com if interested.
Started by Jacob Foster in 1963/64 Cadillac Specific Discussion. Last reply by Jacob Foster 32 minutes ago. 2 Replies 0 Likes
Hey All, good evening! I’m looking to purchase new bushings for my rear trailing arms and rear upper control arm. I’ve read that the replacement bushings for the lower trailing arms are composed of…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Jacob Foster 2 hours ago. 14 Replies 0 Likes
As is with my luck with this car (I still love it to pieces, just needs some TLC from neglect and not being driven) I’ve developed another issue. A small coolant leak has started from the Passenger…Continue
Started by Mark Geertsma in Wanted to Buy 19 hours ago. 0 Replies 0 Likes
Looking to buy the -now seemingly obsolete (?)- NEAPCO 2-9303 double cardan CV joint repair kit for my 63 SdV.Anyone here who has one for sale or knows about an equivalent?Continue
Started by Michael Vogler in General Discussion. Last reply by Michael Vogler yesterday. 2 Replies 0 Likes
Finally got the original factory cruise control in my ‘64 Deville fully installed. It works! (After considerable effort and expense 😳)Thinking about installing the original auto-dim headlights next…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by