I have a 64 Caddy with a Carter carb. My automatic choke sticks wide open once it cools off making it impossible to start. It appears that the piston linkage in the choke assembly is sticking in the bottom of the bore. Any suggestions? I don't believe lubrication is an answer due to it drying up and causing another problem.

Views: 156

Reply to This

Replies to This Discussion

Thank you for your reply. I will have to check my heat riser, that I haven’t done yet.
I have pulled assembly apart, cleaned and readjusted it a few times now.
It seems to be the piston inside the choke housing is binding up in its bore. Is a new housing necessary or can something be done to correct this?

RSS

Photos

  • Add Photos
  • View All

Forum

Interior wood

Started by Jeff Donaldson in Restoration Discussion yesterday. 0 Replies

Quick question......What is the best wood cleaner/polish for the interior wood trim in my 64 Fleetwood?CheersJeffContinue

WTB: passenger side C-pillar trim piece 63 SdV

Started by Mark Geertsma in Wanted to Buy. Last reply by Jason Edge yesterday. 1 Reply

I’m looking for the small passenger side C-pillar trim piece (roughly the division between roof and body) for my 63 Sedan de Ville. This is not the wide molding that extends sideways from the rear…Continue

Rescan of November 1962 Serviceman Bulletin Uploaded

Started by Jason Edge in General Discussion Jan 26. 0 Replies

Back in November I started rescanning the Serviceman Bulletins as a…Continue

Dino Undercarriage Restoration Continues Rearward at the Frame to Body Support Flat Braces

Started by Jason Edge in Restoration Discussion Jan 24. 0 Replies

After making a decent start on cleaning up a section below right rear area of my my 64 Coupe de Ville - Dino's undercarriage, I have been slow to make more progress but in the last couple of days…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service