Automatic choke sticking
I have a 64 Caddy with a Carter carb. My automatic choke sticks wide open once it cools off making it impossible to start. It appears that the piston linkage in the choke assembly is sticking in the bottom of the bore. Any suggestions? I don't believe lubrication is an answer due to it drying up and causing another problem.
Replies to This Discussion
-
Permalink Reply by Wayne Morris on
-
Thank you for your reply. I will have to check my heat riser, that I haven’t done yet.
I have pulled assembly apart, cleaned and readjusted it a few times now.
It seems to be the piston inside the choke housing is binding up in its bore. Is a new housing necessary or can something be done to correct this?
Members
Forum
Power Booster Install
Started by Rob Spring in 1963/64 Cadillac Specific Discussion. Last reply by Rob Spring 1 hour ago. 9 Replies 0 Likes
Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue
1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly
Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin yesterday. 3 Replies 1 Like
Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering. Also, possibly looking for an oil filter housing assembly for a 1964 429 motor. Starting to get…Continue
Complete Front End Rebuild
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata on Thursday. 1 Reply 0 Likes
I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue
A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari Apr 2. 2 Replies 0 Likes
As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 13 Comments 0 Likes
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
