"Thank you Jason"
-
Wayne Morris
- Male
- Coventry, RI
- United States
- Blog Posts
- Discussions (20)
- Events
- Photos (27)
- Photo Albums (1)
- Videos
Wayne Morris's Discussions
body side molding clips
Started this discussion. Last reply by Wayne Morris Feb 4. 5 Replies 0 Likes
Trying to figure out how to install body side moldings. I have my shop manual out, I've searched Caddy Daaddy and am still at a loss as to what clips and other hardware I need to get this job done.Is…Continue
Automatic choke sticking
Started this discussion. Last reply by Wayne Morris Sep 3, 2023. 2 Replies 0 Likes
I have a 64 Caddy with a Carter carb. My automatic choke sticks wide open once it cools off making it impossible to start. It appears that the piston linkage in the choke assembly is sticking in the…Continue
Tags: carborator
Right headlight brow moulding
Started this discussion. Last reply by Wayne Morris Jun 10, 2023. 1 Reply 0 Likes
Nice looking left side headlight brow moulding. I need a right but have two lefts!Asking $100.00 Continue
water manifold on a 64 429
Started this discussion. Last reply by Wayne Morris Apr 30, 2018. 2 Replies 0 Likes
Should there be two o-rings to seal to water pump or just one? I put one and it leaks. USA parts says one. Am I doing something wrong?Continue
Wayne Morris's Page
Latest Activity
"You can see rear qtr fasteners now by Clicking Here."
"I have the fender, door, and rear qtr side trim fasteners and have been selling them for I guess a decade now. I can send pictures and explain how they go on, but I am heading out a for a 5 day road trip to pick up the next parts car. If you…"
"I don't have any clips at this time"
"Is the vehicle sitting in freezing damp weather? May be the brakes are wet and freezing to the drums. Take the car out for a drive and get the brakes hot and see if that cures the problem."
body side molding clips
Trying to figure out how to install body side moldings. I have my shop manual out, I've searched Caddy Daaddy and am still at a loss as to what clips and other hardware I need to get this job done.Is there any body willing to walk me thru this mess?1964, 62 series, 6239, 4 windowThanks,Wayne MorrisSee More
"I have found one so I no longer need one, thanks"
"Thank you for your reply. I will have to check my heat riser, that I haven’t done yet.
I have pulled assembly apart, cleaned and readjusted it a few times now.
It seems to be the piston inside the choke housing is binding up in its bore. Is a…"
Automatic choke sticking
I have a 64 Caddy with a Carter carb. My automatic choke sticks wide open once it cools off making it impossible to start. It appears that the piston linkage in the choke assembly is sticking in the bottom of the bore. Any suggestions? I don't believe lubrication is an answer due to it drying up and causing another problem.See More
"I have most recently found a right brow molding. I still have a spare left"
"I'm still looking for a right brow molding for my 64 series 62. I should be on your list "
Right headlight brow moulding
Nice looking left side headlight brow moulding. I need a right but have two lefts!Asking $100.00 See More
Wiper motors B4 & after
"Thank you for your comment. It has taken me a long time but I’m hoping to be on the road this coming summer. I have owned my Caddy since 1978 and had a 63 Caddy as one of my first cars.
Wayne Morris "
Wiper motors B4 & after
"Looks fantastic! You just need my 3 cad plated screws for the top cover to metal casing. "
Profile Information
- Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
- 1964 62 series sedan 4 WINDOW in process of making it pretty. I have owned it since 1978. It is a So. Carolina car but moved to Rhode Island 15 days after buying it for $50.It had a cracked block & I changed engine during that 15 days.
- Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
- YES 26378
- 1963/64 Cadillac Chapter Member?
- YES
Wayne Morris's Photos
Comment Wall (1 comment)
- At 7:42am on October 10, 2012,
Jason Edge said…
Hi Wayne,
Welcome to the 63/64 Cadillac website.
Jason.
Photos
Members
Forum
Radiator Re-core PLEASE HELP
Started by Scott Santora in General Discussion. Last reply by Dennis P. DiBari 13 hours ago. 4 Replies 0 Likes
I could use some confirmation. I sent out my radiator for my 63 De Ville to get re-cored. Several weeks later, when I went to pick it up from the service vendor, I noticed a large amount of green…Continue
Trivia #29 - What Movie Is this?
Started by Jason Edge in Trivia. Last reply by Cees de Bunje 22 hours ago. 13 Replies 0 Likes
It has been a while since we did some trivia and I was watching a movie last night and saw this 1964 Coupe de Ville that briefly makes an appearance. The Trivia Question is: What Movie Is this?…Continue
1964 Floor braces rot
Started by Todd Fox in Restoration Discussion. Last reply by Todd Fox yesterday. 2 Replies 0 Likes
Has anybody in here found a good supplier of replacement floor braces for the 64 convertibles. Continue
Nice 1963 to 1967 Cylinder Head Water Outlet Pipe Assembly - $150
Started by Jason Edge in For Sale yesterday. 0 Replies 0 Likes
I just pulled a very good Cadillac Cylinder Head Water Outlet Pipe for cars with AC with the extended arm for compressor. That came off a running parts and is a nice piece. Included is a new 180…Continue
Blog Posts
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 0 Likes
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Vintage Air AC
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 0 Likes
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
accumulator dryer
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
'63 Eldorado trumpet horn + 2 standard horns restoration
Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment 0 Likes
My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns.
There is a restoration service called The Horn Works who my son…
ContinueEvents
-
April 21, 2024 - 63/64 Cadillac Chapter Zoom Meet-Up
April 21, 2024 from 8pm to 9:30pm – Zoom
0 Comments 1 Like
© 2024 Created by Jason Edge.
Powered by
