Started this discussion. Last reply by Kevin Robles Jul 15, 2025. 3 Replies 0 Likes
does anyone out there have any experience with seat foam replacement on a 63/64 Cadillac. I had my seats reupolstered many years ago in original leather/fabric and they still look great, but the…Continue
Started this discussion. Last reply by Jason Edge Jan 16, 2015. 6 Replies 0 Likes
Anybody out there have any experience or direction how to remove and replace the chrome trim moulding around the front door window glass? KevinContinue
Posted on July 29, 2015 at 11:19pm 3 Comments 0 Likes
Has anyone had good luck with a replacement gas tank? I need to replace my gas tank in my 64 CDV and as I look around I see advertised replacement tanks that will work, but the fine print states that they are 4 gal less than the original tank. Cadi's aren't known for their fuel economy. Would like to find something with the same gallons. Anyone have any experiences to share? Thanks Kevin
Posted on June 18, 2014 at 11:31pm 2 Comments 0 Likes
Has anyone had any experience with refurbishing their dashboard. while reviewing the vendors website that is listed on the 63/64 website, it seems like a long and expensive proposition. Anyone had and good luck with any Vendor out there that you might recommend. Anyone got an idea on what I should be paying? any advice would be welcome
Posted on February 21, 2014 at 12:04am 0 Comments 0 Likes
I have a question. My 64 CDV is down for a complete paint and interior redo. When I disassembled the interior I found 4 hard rubber blocks under the front seat attachment bolts. Has anyone seen this before or did someone before me put these in to raise the height of the seat. Secondly, I was wanting to install new headlamps that would give better lighting for nighttime driving. Has anyone had experience installing the HID lighting in lieu of the standard sealbeams? Any advice would be…
ContinuePosted on November 10, 2013 at 9:09am 1 Comment 0 Likes
I recently completed a complete engine rebuild on my 64 CDV. I have a continuing problem (both before and after the rebuild). When I am stuck in traffic and the car begins to run real hot, but not overheated, the car runs very rough and will stall out unless you are able to make it out to open road in which it will sputter a bit, but begin to run perfectly once the operating temp drop down a bit. I have replaced the carb at a different time from the rebuild and it made no difference, the…
ContinueHi Kevin,
Welcome to the New 63/64 Cadillac Chapter.
Jason.
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Jacob Simmons 16 hours ago. 13 Replies 0 Likes
As is with my luck with this car (I still love it to pieces, just needs some TLC from neglect and not being driven) I’ve developed another issue. A small coolant leak has started from the Passenger…Continue
Started by Bill Wolf in General Discussion. Last reply by Dennis P. DiBari on Tuesday. 6 Replies 0 Likes
I am trying to replace the front wheel cylinders on my 63 SDV and can't figure out how to get a wrench on the bolts holding them on. Does the backing plate have to come off and if so, how? Thank you…Continue
Started by Anthony Vanacore in For Sale. Last reply by Anthony Vanacore May 6. 5 Replies 0 Likes
Hello,My father and I are restoring our 63 series 62 conv, we had the chrome bezels for the window/seat switches rechromed. During this process we also installed factory power door locks to the…Continue
Started by Jason Edge in General Discussion May 3. 0 Replies 0 Likes
As I was documenting the non-AC 63 Eldorado parts car I bought in a couple months ago, the solid panel dash end panels intrigued me and thought I would share a couple of pictures and thoughts. First,…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
May 17, 2026 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2026 Created by Jason Edge.
Powered by