"Thank you very much! Well put it to good use. Rob. "
Rob Spring's Discussions
Power Booster Install
Started this discussion. Last reply by Rob Spring Apr 8. 9 Replies 0 Likes
Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue
Rob Spring's Page
Latest Activity
"Rob, I included one of these nylon seals with your latest order. Jason. "
"Thanks everyone for your insight."
"I think that the gasket is more of a chaff guard that a seal. The original material of the seal is a nylon material or something like that. As an Aircraft mechanic for more than 37 years, that material type is used as an anti chaff between…"
"The gasket is usually attached with adhesive to back of booster so yes I think it became part of the booster and probably why not listed in the Master Parts Book. I don't recall ever seeing a thick grommet like the one you attached. …"
"Hi Russ,
I replaced my PB Booster last year and mine was part of the booster on my 1964 Series 62. I believe you are correct.
Dennis DiBari"
"Thanks! I haven’t found that gasket either but was going to use a gasket making kit for it. In addition to that seal there is a rubber firewall grommet which is what I’m trying to track down. Attached is a Chevy one that seems somewhat…"
"You got me curious and I looked at the boosters I have in stock. There is a gasket on all of them so it must be part of the booster itself. "
"The parts book does not show a gasket for the 63 64. It lists up to 58 for a body gasket. The corvette world has alot of reproduction parts that may work. "
Power Booster Install
Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific replacement seal set into the firewall. Mine is done and wanted a replacement if anyone can point me in the right direction. Photo is attached. Any other insights into this process always appreciated. Also thanks to the knowledgeable Jason Edge for calling out the finish of the firewall paint.RobSee More
Profile Information
- Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
- 1963 Coupe deVille
- Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
- 33301
- 1963/64 Cadillac Chapter Member?
- Yes
Comment Wall
- No comments yet!
Photos
Members
Forum
headlight / dimmer switch confusion (63 Sedan Deville)
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf 6 hours ago. 2 Replies 0 Likes
The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue
Original Keys
Started by Logan Robb in 1963/64 Cadillac Specific Discussion 20 hours ago. 0 Replies 0 Likes
Rear main seal
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Phillip Hill yesterday. 2 Replies 0 Likes
Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue
May 2025 Spotlight - Lois & Rob Harriman 1963 Coupe de Ville & Richard Stanley 1964 Eldorado
Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Joseph Innamorato yesterday. 3 Replies 0 Likes
Continuing what I started last month, I have updated the website header at www.6364cadillac.com to spotlight two more Chapter…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
