Not to repeat my newsletter article but I'm in rapid milestone mode this year, with my 64 CDV rolling down the assembly line 50 years ago on March 19, 1964, me rolling down the assembly line on December 26, 1964 (yeah, call me old man Edge in December), and me and my wife celebrate our 20th anniversary in 2 days on April 10th. We have a short beach trip with the pooches planned thru Saturday and will be off line. Saturday I turn around and head to Richmond for Parts Car #41 so will be busy and pretty much out of commission through Sunday.

It's also been a fun 2 years celebrating the 50th birthday of all of our 1963's and 1964 Cadillacs and featuring them in our newsletters and look forward to sharing many more milestones with all of you.

I'll leave you with an earlier picture above and later picture below of me and my partner in crime in these Cadillac Adventures!

Views: 250

Facebook Facebook

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Photos

  • Add Photos
  • View All

Forum

Swapping 429 engine crankshafts

Started by Jacob Foster in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 1 hour ago. 5 Replies

Hello All! I’m struggling to find an answer to this question, hoping a member can help. Can I swap the crankshaft from a 1966 429 w/TH400 to my 1964 429 w/TH400 trans? I came across an article that…Continue

1963/64 Cadillac Chapter July 2025 Newsletter Posted

Started by Jason Edge in Newsletters. Last reply by Dennis P. DiBari 14 hours ago. 1 Reply

I have just completed and posted the July 2025, 1963/64 Cadillac Chapter Newsletter to our…Continue

Tags: Chapter, Newsletter, Posted, Cadillac, 1964

1963 AC evaporator core leaking?

Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton yesterday. 4 Replies

Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue

Tags: 1963, core, evaporator, AC

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Tony Prichard on Thursday. 4 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service