Need some expert advice. A few days ago I lost all power window operation. Upon further investigation I found that the red power wire was severed in the door hinge area where they are common to breaking. I also found others that were close to being broke. Repaired the red one first and all windows operated except the passenger side door. (I replaced the motor in that window a little over a year ago and it had worked until I lost power to all of them). I went ahead and repaired the wires that were close to breaking but that did not change anything as far as the passenger front window operating. Whenever I operate the window button on either the master control panel on the drivers side or the button on the front passenger door I can hear clicking as if a relay is operating and the door courtesy lights will dim so pretty sure I am getting power there but no window function. I just find it strange that it quit working after the main power wire was severed, but all others work fine once that repair was made. I did find a green wire hanging down under the dash next to the steering column, but it was hanging down before this issue arose. I never could figure out where it belonged, but it looks as if it had broken at one time. (I am attaching a couple of photos of that wire to get some input also. That wire comes out of a connector that has a white wire coming out of both ends and the green out of just one side) Probably two unrelated situations but thought I would see if anyone can provide some answers on either one and/or what to check next. Thanks, Doug
Comment
Tim, if you need some cores, I have a lot of slow moving, non working ones, gears and parts. I''ll pop the top gear out, clean regrease, bench test, but that's about all I have time to do with my full time job. Shoot me an email and will make you a real good deal on cores.
Thanks, Tim. I tried what you said and here are the results. Red feed in switch had power and when I connected to other ports (one at a time) just heard a click, but no motor operation. Also checked the drivers side door switch with same results. Sounds like a bad motor to me which is unfortunate as it is only a year or two old. Of course no warranty on electrical parts. I ordered the last one from USA Parts Supply as a new motor (150.00 plus shipping). OPGI offers them also as remanufactured originals but are about 190.00 plus shipping). Any suggestions? Has anyone had luck with a certain company making good quality motors for reasonable price? USA Parts Supply always treats me like dirt so not to anxious to use them again. Do you think the motor is the issue? Don't know what else the problem could be. Thanks again for your excellent advice. Doug
Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 14 hours ago. 1 Reply 0 Likes
My brother Randall (Randy) Edge has been helping me off and on for many years with traveling to pick up parts cars all over the east cost, to almost anything and everything I need help with around…Continue
Started by Sammy in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 5 Replies 0 Likes
Summer is coming, and now the next frost plug is leaking.Has anyone ever done these?Which kind of plugs did you use and where to buy them?Read a lot about "adjustable" plugs and sealants - but not…Continue
Started by Jason Edge in Trivia on Saturday. 0 Replies 0 Likes
Yesterday, after struggling with other tools to disassemble a part using some not quite right tools, I decided to use the car frame as a "jig" to hold the part in place while I removed the other…Continue
Started by Jason Edge in Trivia. Last reply by Jason Edge on Saturday. 1 Reply 0 Likes
Ok. Here is a fastener I see about every day working with my big inventory of fasteners, and thought it was worth posting as trivia. If you saw my post on Facebook (I do sell them), wait to see if…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website