My Eldorado has bucket seats.  The controls lack tilt.  Is this how they came? 

ithe door mounted control knob has forward/back and up/down but, no tilt.  
the up down isn’t working at the moment and forward/back is sluggish and pulls more from one side of the tracks.  

Views: 127

Reply to This

Replies to This Discussion

They came with 4 way (up, down, forward, back) on the driver side, and 2 way (forward and back on the right side).  If you want them to tilt back you can always unbolt front and add some rubber blocks under the front.   

- For non movement check the transmission on the left driver side for dried grease. Unbolt driver seat, flip back, and remove the transmission, open the case, and remove all dried grease especially on the slide rods that the electromagnetic actuators engage to pull the gears together to make the seat cables spin. The grease dries up and prevents movement of the actuators. Click on Seat Transmission - Cleaning the 6-Way and 4-Way Seat Transmissions to go to our Help Page for a visual and more details on cleaning. 

- For slow movement, unbolt seat, flip back clean out the tracks with WD40, 0000 steel wool, compressed air and whatever you have to work with. Also check that the main ground wire is secured to the floor. It usually a thick blue wire with an round connector that goes under one of the seat rail to floor bolts. Give the bolt and extra snug and make sure it is tight.  Also makes sure seat left and right rails are in same relative position front to back. Simply measure from front or back for equal distance.  Motor could be tired and burning out but usually cleaning and greasing seat rails and checking that ground will do the trick. Also make sure the seat harness connectors at motor and transmission are making good contact. Pull apart and clean if unsure. 

Thank you for answering the question. 
I was just watching the online dealers information and trying to pause the slideshow on the Eldorado seat page.  

‘’I’ll copy down the repair details for action when time permits.  

RSS

Photos

  • Add Photos
  • View All

Forum

Burning Rubber

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks on Thursday. 5 Replies

Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light?   Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue

Gas gauge only reads half when full

Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply

Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue

64 Brakes

Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply

Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue

Heater Core Replacement

Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson on Sunday. 6 Replies

I'm currently rounding up parts for a heater core replacement in my 1964 Deville.  I'm looking for replacement hoses that connect to the heater core itself.  It's a factory a/c car and has the metal…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service