heater hose
I am replacing my heater hoses and was wondering if anyone has found a replacement for the 1479723. Its the 3/4" hose that goes from the heater core to the pipe running under the intake. Thanks
Replies to This Discussion
-
Permalink Reply by Larry Rees on
-
This is for a 64 Deville
-
-
I have tried to use a hunk of 3/4" off the roll but it starts to kink when bent in the small area. The hose that I removed was molded. It had the mold close enough to work but no part number left on it. The original part number 1479673 is no long any good but was looking for a conversion to a newer part number of a hose that is close enough to work without kinking.
-
-
Thanks good advice
-
Permalink Reply by Jason Edge on
-
Anyone have a good replacment # for Larry? I have replacement #'s for all the other hoses but would like to have a couple for this one. So, if you have a replacement # give us a shout. (Yes, I know we can all march to the auto store and have some one match one up, but we are looking for someone that has made that trek and id'ed a good replacement hose.)
-
Permalink Reply by David Thomas on
-
I us NAPA .75 inch 90 degree hose from the heater core to under manifold pipe. I think the part number is 9816. I trimmed the excess to fit. I use their 90 dgree .625 inch hose for the thermostat nipple to valve and from the valve to the heater core. Also trimmed to fit.
-
-
thanks
Photos
Members
Forum
Burning Rubber
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Kurt 21 hours ago. 7 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Gas gauge only reads half when full
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue
64 Brakes
Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari Feb 16. 1 Reply 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Heater Core Replacement
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson Feb 15. 6 Replies 0 Likes
I'm currently rounding up parts for a heater core replacement in my 1964 Deville. I'm looking for replacement hoses that connect to the heater core itself. It's a factory a/c car and has the metal…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
