heater hose
I am replacing my heater hoses and was wondering if anyone has found a replacement for the 1479723. Its the 3/4" hose that goes from the heater core to the pipe running under the intake. Thanks
Replies to This Discussion
-
Permalink Reply by Larry Rees on
-
This is for a 64 Deville
-
-
I have tried to use a hunk of 3/4" off the roll but it starts to kink when bent in the small area. The hose that I removed was molded. It had the mold close enough to work but no part number left on it. The original part number 1479673 is no long any good but was looking for a conversion to a newer part number of a hose that is close enough to work without kinking.
-
-
Thanks good advice
-
Permalink Reply by Jason Edge on
-
Anyone have a good replacment # for Larry? I have replacement #'s for all the other hoses but would like to have a couple for this one. So, if you have a replacement # give us a shout. (Yes, I know we can all march to the auto store and have some one match one up, but we are looking for someone that has made that trek and id'ed a good replacement hose.)
-
Permalink Reply by David Thomas on
-
I us NAPA .75 inch 90 degree hose from the heater core to under manifold pipe. I think the part number is 9816. I trimmed the excess to fit. I use their 90 dgree .625 inch hose for the thermostat nipple to valve and from the valve to the heater core. Also trimmed to fit.
-
-
thanks
Members
Forum
window regulators
Started by Frank Murch in 1963/64 Cadillac Specific Discussion 23 minutes ago. 0 Replies 0 Likes
For years my winds have seemed to be looser and less accurate than most modern windows. I am thinking the soft parts are worn. Has anybody gone through thier window regulators and felts to restore…Continue
Replace Choke Tube or Install Electric Choke?
Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal yesterday. 4 Replies 1 Like
My mechanic has sourced a choke housing and new internals. As you might expect, the choke tube is damaged and or clogged. My options are to either replace the choke tube, or my mechanic recommends…Continue
Tags: Electric Choke, Choke Tube
Correct whitewalls
Started by Richard Stanley in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
I just replaced my tires from Diamondback (I had bad results in the past from Coker). It was the second time, due to the age of the tires. About 18 years ago Diamondback made custom whitewalls…Continue
Dino Radiator Leak - Time to Recore!
Started by Jason Edge in General Discussion. Last reply by Jason Edge on Thursday. 35 Replies 0 Likes
I had brought up the topic of radiator leaks as a discussion topic for our Chapter Zoom meet-up this past Sunday and thought I would share on our website for everyone and probably do a more formal…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
