I am in the middle of doing a carburetor update and I am planning on blocking out the middle exhaust ports on the in manifold as per Jason's instructions on doing this update. I am going to install an Edelbrock 1406 carb with electric choke. In the instructions Jason mentions that the intake manifold gaskets should be updated to the thicker kind in order to seal around the metal plate being added to block off the exhaust passage that goes through the intake manifold on the production set up. Does any one have a place that I can order those type gaskets either online or at an auto parts store. I am only finding either the same thin type gaskets that are already on the car and won't seal properly, or what looks to be a gasket made from rubber from a company called Fel-Pro, and I don't know if those will do the trick. I know that I am not the first one to do this update so where can I get the proper gaskets from? Any suggestions will be greatly appreciated.
Tags:
Here is where I got mine https://vintagecarburetorsandgaskets.com/shop/intake-manifold-set-1...
Hey Pat ,
give me a call ,I’m in the middle of doing my carburetor project right now. I have some useful info for you .email me at schrym@aol.com I’ll send you my number
Thanks Ray.
Started by Jason Edge in General Discussion. Last reply by Kurt 3 hours ago. 6 Replies 0 Likes
I have got a flood of email, texts, about the 63 Eldo that recently bid up to $120,000 and thought I would share for those that have not seen it.Here is the link:…Continue
Started by Jason Edge in General Discussion 6 hours ago. 0 Replies 0 Likes
Incredibly, in 3 days I have had 3 people ask about replacing their fuel pump or even adding an electric fuel pump because there carb is not getting gas. It has gotten to the point I have copied and…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 13 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Monday. 3 Replies 0 Likes
While enjoying the fruits of my labor on all new rear suspension and…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by