I need a little help with my THM transmission lines. I need to know what any fastening hardware looks like and where to fasten them. Any help is much appreciated.
Tags:
Yes!!! Thank you. And I see where they are attached right before the starter. Are there any more? I want to thank everyone who has helped out. Trying to finish this up after 19 years of messing with it.
Bought a new set some years ago at OPGI, linings fit perfect but connections between rad and lines AND trans and lines were planned direct, no rubber hoses between.
That is the right way, no rubber hoses.
Original is with small rubber hoses between on both ends.
Different on the 64?
Bill, I meant to get back to this yesterday but never made it back here. The 1964 Turbo Hydramatic has 2 metal lines from transmission to radiator. This is completely different setup from the 1963-64 Hydramatics that had short rubber hoses at the transmission.
So back to the 64 THM, there are fittings that screw into the transmission and fittings that screw into the bottom of the radiator. They looks similar but are a bit different and I have them for $10 each.
As far as the lines bracing against the engine as it runs forward:
Travis J. Hensley Online
Started by Jason Edge in Newsletters 7 hours ago. 0 Replies 0 Likes
I have just completed and posted the July 2025, 1963/64 Cadillac Chapter Newsletter to our…Continue
Tags: Chapter, Newsletter, Posted, Cadillac, 1964
Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton 18 hours ago. 4 Replies 0 Likes
Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue
Tags: 1963, core, evaporator, AC
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Tony Prichard yesterday. 4 Replies 0 Likes
I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue
Started by Bobby Brown in General Discussion. Last reply by Tony Prichard yesterday. 7 Replies 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by