When fixing the turn signal switch in my 64, I found out that the spacer is missing in steering column. This is non-tilt version. with amazing luck I managed to acquire missing spacer within few days.
Which position the spacer should be installed? Based on diagram, the pin is facing down. I wonder if anyone has photo how the spacer is positioned.
Tags:
This spacer is not only making the cancel of turning signal, but it keeps that upper bearing tight. Without the spacer the bearing is sloppy and steering wheel feels a bit loose.
The pin in spacer need to point upward and goes to the hole in bottom of the steering wheel.
Somebody has been trying to repair the turn signal switch and did not install the spacer anymore for whatever reason.
Started by Jason Edge in 1963/64 Cadillac Specific Discussion 4 hours ago. 0 Replies 0 Likes
CLC Membership dues are going up April 1. Join or Renew between now and March 31 and save! You can even renew with current rates for up to 3 years!Here is a breakdown of the rate increases Effective…Continue
Started by Jason Edge in Chapter Discussion yesterday. 0 Replies 0 Likes
Here is a breakdown of the rate increases Effective April 1:E-membership…Continue
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge yesterday. 2 Replies 0 Likes
I often receive requests for good 1964 AC Heat Comfort Control Power Servo’s and/or Transducers. I currently have 6 Power Servos and 3 transducers and all leak down with the vacuum pump. Some look…Continue
Started by Jacob Foster in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks on Monday. 2 Replies 0 Likes
Gents, good morning!I’m looking for advice on how to fix the A/C Power Servo on my 1964 Cadillac Deville. The unit itself seems to be working correctly, but the vacuum actuator is leaking off. Has…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
January 18, 2026 from 7pm to 8:30pm – Zoom
2 Comments 0 Likes
© 2026 Created by Jason Edge.
Powered by