Loud air moving sound within carb with cleaner removed

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Views: 174

Facebook Facebook

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Dennis P. DiBari on March 27, 2024 at 3:28pm

Hi Dave,

     It sounds like you checked everything.  As Jason said, there is a normal vacuum sound when you remove the air cleaner.  I have a 4-barrel Rochester on my 64, so it is a bit different than your Carter.  If you checked all the lines that Jason mentioned, then you should be OK.  The booster, vacuum advance, PCV valve are all big vacuum items.

Dennis DiBari, Cottekill, NY

Comment by Jason Edge on March 27, 2024 at 2:38pm

With the air cleaner off you will get an air sucking sound. I listened to your video not sure I hear anything too out of the ordinary. With cleaner on do you still hear loud or pronounced air sound? 
If all of your vacuum hoses are good and tight and you have checked the devices they operate (e.g. vacuum advance, brake booster, throttle check valve (if equipped), AC idle speed-up control, if equipped, etc. If you have issues inside the cabin I don't think you would hear from engine compartment. For that with car running stick your head under dash, with AC/Heat on moving controls then try to set unset park brake via gear shift (obviously not with head still under dash). 
You should be able to isolate a specific leak, but again you do get a sucking sound when you take that air cleaner off. I will try to give mine a listen with filter off and compare but it is raining cats and dogs here right now and cannot get car outside.  

Comment by Kurt on March 27, 2024 at 9:16am

Is the car running badly? Sounds normal to me.

Comment by Dave Fehrle on March 26, 2024 at 10:43pm

Had some time today to check vacuum hoses out of the manifold as well as the one into the carb from the dist check valve. All 3 were good with no hissing. Even took them off and pushed air thru with no holes or splits. I took a video of the carb while the car was running to get the sound from the carb(see attached). 
I believe my heat riser is stuck in closed position, thus causing left exhaust to flow thru the manifold and that is what is making the sound. Any other ideas?

IMG_5205.MOV

Comment by Dave Fehrle on March 25, 2024 at 3:47pm

Thank you for all the helpful ideas, I will start the search and report back!

what size is the small vacuum line coming off the manifold?

Comment by Mike Travers on March 25, 2024 at 10:15am

Not sure about the paper over the carb but the hissing is not normal and is, almost always, a vacuum leak. In order to help find the leak, you can go to your parts store and buy about 3' of rubber vacuum hose (any size) and use it as a makeshift stethoscope. Once back in your garage, put one end in your ear and move the other end across your running engine and the hiss will get very loud when you move the open end of your hose over the leak. Viola! You've found the leak. 

I hope this helps you find your issue.

Comment by Dennis P. DiBari on March 24, 2024 at 7:55pm

Hi Dave,

     As Chris said, put your ear close to each of the vacuum hoses around the carburetor and intake manifold.  With the heat, they become brittle.  Look specifically at the 11/32 vacuum hose to the check valve off the power brake booster (it must be 11/32 vacuum hose, not 3/8 heater hose!!!).  Also, look at the vacuum hose cluster coming out of the firewall - they go to the heat control valve and the vacuum pot near the heater core.  My hoses cracked at the firewall, and I had to repair them to get my heater to work again.  Good luck and let me know!

Dennis DiBari, Cottekill, NY

Comment by Chris McBride on March 24, 2024 at 12:25am
Check for vacuum leaks, a common source for hissing noises. The vacuum hoses commonly become hard and brittle after enough time in the heat of the engine compartment. They often harden and leak at the end points. You can sometimes snip of the offending end and reattach the more pliable remaining hose. Vacuum hose is also comparatively cheap.

I hope that this resolves the hissing noise since the other possibility, a leaking intake manifold, is a far more problematic issue.

I have no idea if paper should remain immobile above an idling engine.

I hope that you find a leaking hose since another possible issue, a leaking intake manifold, is a more problematic issue.

Let us know what you find out.

HTH

Chris

Chris

Photos

  • Add Photos
  • View All

Forum

Logans Intake Project, 1964 Fleetwood, Progress Report #1

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 12 hours ago. 4 Replies

I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue

Rear main seal

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Phillip Hill yesterday. 4 Replies

Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue

1963 Cadillac differential 3.25

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Thursday. 2 Replies

I have a 1963 Cadillac differential with 80K on it. Found a limited slip a while back, and I do not think I will ever used the original diff.  In is in carlsbad California 92009.  Let me know if you…Continue

headlight / dimmer switch confusion (63 Sedan Deville)

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 3 Replies

The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service