I recently brought in an original, unrestored 1963 Indiana license plate and posted on another thread and it was suggested we post pictures of our vintage, antique or personalized plates we run on our 1963/64 Cadillacs. 

I will start this off by showing a full rear shot of my 64 Coupe de Ville with an original 1964 North Carolina license plate.  In NC you can run a correct vintage plate as long as you keep the current license plate and registration in the car. Unlike some states they are not linked.  My plate is like new and believe it was restored.  I bought it so long ago now I can't remember!

If you have a unique plate on your 63/64 Caddy please share! Maybe we will run these in a future newsletter. 

Views: 364

Reply to This

Replies to This Discussion

Here's my 64 NY Plate

 Very cool plate.  Neat to see the NY World’s Fair promoted.

Very nice Fleetwood! I don't see many of those on the page. Nice and bright taillights too! I need to do some work on mine to brighten them up. Clean ground and some fresh bulbs are in order...

Oh, and nice plate!

Thanks! I replaced the lenses with repros and also sprayed the inside of the housings with chrome spray paint in addition to cleaning up the sockets. Seemed to help a lot.

That can help a lot. I did a batch of the 63 tail lamps last year and will do a batch of 64's at some point later this year! Here is a before and after with the 63 tail lamp.

How important is the gasket that is in that housing? My gasket are present, but not in good shape by any means. I have been wanting to spray my TL lenses as the photo above, but I dont want the gasket to crumble as I know it will!

Are there repops that I can use?

Here is the correct year CA plate currently on my de Ville. It is not the original plate of the car.  The Texas plate below was from my first de Ville that I had in the 1980s.

RSS

Photos

  • Add Photos
  • View All

Forum

Trouble with the transmission in my 1963 Fleetwood

Started by David Michael Bigeleisen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 15 hours ago. 1 Reply

Dear Cadillac friends:I have a 1963 Fleetwood.The transmission dipstick has bubbles in it when I check the fluid.Also, the transmission shudders when I drive up a slight incline in reverse.I had the…Continue

CLC Membership dues are going up April 1. Join or Renew before March 31 & Save!

Started by Jason Edge in Chapter Discussion. Last reply by Jason Edge on Tuesday. 1 Reply

Here is a breakdown of the rate increases Effective April 1:E-membership…Continue

Sneak Peek at our Next Newsletter Feature - Denis Binette's 14K Mile Coupe de Ville

Started by Jason Edge in Newsletters on Tuesday. 0 Replies

Here is another sneak peak of our next newsletter feature - Denis Binette's 14K mile 1964 Coupe de Ville. I hope to have this distributed within the next couple of weeks. …Continue

Rear Main Seal & Transmission Pump Seal

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by CHRIS CARLSON Feb 27. 1 Reply

Hey everyone, I need to replace my transmission input seal before spring starts, I’ve been losing a lot of fluid post Sunday drive. I figured I’d do the rear main seal service bulletin at the same…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service