Tags:
THise rubber tits are the oil pan gasket as pictured below. For the rear main seal, DO NOT USED Best Gasket brand as it is a known defective seal The company knows about it and continues to sell them.
Get a good rear main seal from Caddy Daddy. Use a seal saver on the harmonic balancer to repair the lip in the sealing surface.
Thank you! Learned something new about the front and rear gaskets on the oil pan!
Russ, not familiar with a seal saver for the harmonic balancer?
Hi Dave,
I haven't had to use one, but if there is a groove in the harmonic balancer (the part that fits onto the crankshaft), the thin seal saver can allow a smooth rotation near the front seal. Russ is 100% right. It might tap on easier if H. Balancer is frozen and sleeve is heated in oven.
Dennis DiBari
Started by David Michael Bigeleisen in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
Dear Cadillac friends:I have a 1963 Fleetwood.The transmission dipstick has bubbles in it when I check the fluid.Also, the transmission shudders when I drive up a slight incline in reverse.I had the…Continue
Started by Jason Edge in Chapter Discussion. Last reply by Jason Edge on Tuesday. 1 Reply 0 Likes
Here is a breakdown of the rate increases Effective April 1:E-membership…Continue
Started by Jason Edge in Newsletters on Tuesday. 0 Replies 0 Likes
Here is another sneak peak of our next newsletter feature - Denis Binette's 14K mile 1964 Coupe de Ville. I hope to have this distributed within the next couple of weeks. …Continue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by CHRIS CARLSON on Saturday. 1 Reply 0 Likes
Hey everyone, I need to replace my transmission input seal before spring starts, I’ve been losing a lot of fluid post Sunday drive. I figured I’d do the rear main seal service bulletin at the same…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by