Dave Fehrle's Discussions (45)

Discussions Replied To (34) Replies Latest Activity

"I mean wheel cylinder not control valve!"

Dave Fehrle replied on Thursday to Bleeding brakes

3 on Thursday
Reply by Russ Austin

"Got to spend a few hours continuing the rear suspension work with the info provided…"

Dave Fehrle replied May 25 to Rear suspension project

4 May 26
Reply by Dennis P. DiBari

"Unfortunately, the gas tank is just an few inches away as is the overflow tube, so t…"

Dave Fehrle replied May 11 to Rear suspension project

9 May 13
Reply by Robert Alan Shannon

"Still no luck on getting the spherical joint to release. I even tried loosening the…"

Dave Fehrle replied May 10 to Rear suspension project

9 May 13
Reply by Robert Alan Shannon

"Thanks Russ! I have not been able to get the spherical joint to release from the dif…"

Dave Fehrle replied May 10 to Rear suspension project

9 May 13
Reply by Robert Alan Shannon

"Hey Righty, I was wondering how your recovery was coming along! Sounds like you are…"

Dave Fehrle replied Mar 12 to Just Checking in Post Surgery!

4 Mar 16
Reply by Dennis P. DiBari

"Let’s try this one!"

Dave Fehrle replied Feb 17 to Carb noise

5 Feb 19
Reply by Russ Austin

"Dennis, I had time to run over and correct the choke spring setup and sure enough, w…"

Dave Fehrle replied Jan 1 to Carter carb choke/fast idle cam

10 Jan 2
Reply by Dennis P. DiBari

"Dennis, thank you for checking your fast idle cam. And now that I think about the ch…"

Dave Fehrle replied Jan 1 to Carter carb choke/fast idle cam

10 Jan 2
Reply by Dennis P. DiBari

""

Dave Fehrle replied Jan 1 to Carter carb choke/fast idle cam

10 Jan 2
Reply by Dennis P. DiBari

RSS

Photos

  • Add Photos
  • View All

Forum

Dino Diaries - July 11, 2025 - Busted!

Started by Jason Edge in General Discussion. Last reply by Jason Edge 5 hours ago. 4 Replies

So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Thursday. 3 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Getting hot when going fast…

Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 6 Replies

So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service