Fuel gauge needle bouncing
Hi everyone,
I'm in the midst of diagnosing two fuel gauge problems. Originally it would only read half full after filling up.
After replacing it with a recalibrated gauge, now the needle bounces like crazy all over the place when the car is moving.
I'm assuming there's some sort of chafed ground somewhere - the tank and sender are brand new, sender was bench-tested. The fuel gauge is also recalibrated.
Any ideas on places to look very closely?
Thanks!
Replies to This Discussion
-
Permalink Reply by Dennis P. DiBari on
-
Hi Ken,
How about the ground wire off the gauge, that runs to the rear of the car with a bolt on the rear frame. It is near/under the license plater cover. Make sure it is cleaned and tight. Take a look at it.
Dennis DiBari ,NY
-
Permalink Reply by Kenneth Barton on
-
I was so confident that wasn’t it…until I looked closer and realized the screw wasn’t holding the ground tight to the metal. I switched to a traditional nut and bolt and bam! Rock steady.
Thanks Dennis!
-
-
Hi Ken,
Very glad that it worked for you. That is usually the culprit - good work on your part that you fixed it!
Dennis DiBari
Photos
Members
Forum
WTB: 1963 Double Cardan CV Ball Socket Repair Kit (NEAPCO 2-9303)
Started by Mark Geertsma in Wanted to Buy 7 hours ago. 0 Replies 0 Likes
Looking to buy the -now seemingly obsolete (?)- NEAPCO 2-9303 double cardan CV joint repair kit for my 63 SdV.Anyone here who has one for sale or knows about an equivalent?Continue
Original ‘64 Cruise Installed.
Started by Michael Vogler in General Discussion. Last reply by Michael Vogler 14 hours ago. 2 Replies 0 Likes
Finally got the original factory cruise control in my ‘64 Deville fully installed. It works! (After considerable effort and expense 😳)Thinking about installing the original auto-dim headlights next…Continue
A Big Welcome to the 63/64 Cadillac Chapter to my Brother Randy
Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Randall (Randy) Edge on Wednesday. 2 Replies 0 Likes
My brother Randall (Randy) Edge has been helping me off and on for many years with traveling to pick up parts cars all over the east cost, to almost anything and everything I need help with around…Continue
Frost plugs
Started by Sammy in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari May 23. 5 Replies 0 Likes
Summer is coming, and now the next frost plug is leaking.Has anyone ever done these?Which kind of plugs did you use and where to buy them?Read a lot about "adjustable" plugs and sealants - but not…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
Videos
© 2026 Created by Jason Edge.
Powered by
