Well, things were just going too good for too long.

went out this a.m.  Hit the key, got nothing but a click,, not the click click click of a dead battery, but a click.

turned off, tried again, nothing but a click,  I checked the battery connections and the ground connection to back of starter.  all good battery was full charged.  Tried again, just a click,  

I left, came back later, nothing but a click.  waited, later, same thing,  then went to internet search to see what that meant. wast happy with answers.  went back out, hit the switch, engine fired right up!!  What the hell!!   I know this will happen again, so im looking to fix it

soo,  the obvious questions.  IS this solenoid? and how do I check it,  or, is it starter, and how would the separation of part that's damaged be determined?

I havnt noticed any plasticy wire burning smells,  car has been running great,,,

Views: 190

Reply to This

Replies to This Discussion

I haven't done this in a long time but auto parts stores used to test starters and solenoids for you. Call your local parts stores and ask if they still do that.

I would double check all wires, including grounds on cranking circuit and make sure car is firmly in park … even jiggling the lever a bit. If not firmly in gear or neutral safety switch is a bit off it will not crank … but usually doesn’t even make a click.

I would check the NSS first. Next time it does it, rock the shifter lever a bit to see if the car starts. 

Russ, Jason,, I m running without a NSS.. the one I got from Russ a while back cracked so Im just in the habit of always checking the park at start and stop,  and not parking behind another car.  

This morning, I went out to give it a go, and it just started right up,, Never flinched, just started.  maybe it just needed a jiggle, but im gonna have to try and see what that was in the next few days,, bad weather coming up here for a couple days, 

Give the connector another squeeze with the pliers to see if it is loose. (the connected wires on the NSS circuit)

I hvnt been able to work on car due to weather. Went out today and it started fine.

My question is, if it is a starter,solenoid problem, is this a progressive condition?  By that i mean will it get worse or just be a hit or mis non start?  Strangely,  my 05 diesl is dead due to a 1295 code, sold the 73 eldo, so the 63 is my primary car that i now trust to start (73 WAS MYBALWAYS START go to) and its gone,  so if its a on off thing till incan get into it fully, i can get by, but if its gonna just die an i getvstranded, i hv to try to figure out some thing quick

RSS

Photos

  • Add Photos
  • View All

Forum

Rescan of November 1962 Serviceman Bulletin Uploaded

Started by Jason Edge in General Discussion on Monday. 0 Replies

Back in November I started rescanning the Serviceman Bulletins as a…Continue

Dino Undercarriage Restoration Continues Rearward at the Frame to Body Support Flat Braces

Started by Jason Edge in Restoration Discussion on Sunday. 0 Replies

After making a decent start on cleaning up a section below right rear area of my my 64 Coupe de Ville - Dino's undercarriage, I have been slow to make more progress but in the last couple of days…Continue

1964 Cadillac wagon by Victor Body Works

Started by john w. warner in For Sale. Last reply by Logan Robb Jan 22. 2 Replies

Its on Hemmings.Needs work!Continue

1963 Cadillac Fleetwood 60 Special Eyebrow Molding

Started by Stephen Pechenik in Restoration Discussion. Last reply by Russ Austin Jan 21. 6 Replies

I am readying my Fleetwood to be painted.  I need to replace the driver's side left chrome eyebrow molding (below the headlights).  It appears to be made from pot metal.  Mine is broken and I need to…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service