Well, things were just going too good for too long.

went out this a.m.  Hit the key, got nothing but a click,, not the click click click of a dead battery, but a click.

turned off, tried again, nothing but a click,  I checked the battery connections and the ground connection to back of starter.  all good battery was full charged.  Tried again, just a click,  

I left, came back later, nothing but a click.  waited, later, same thing,  then went to internet search to see what that meant. wast happy with answers.  went back out, hit the switch, engine fired right up!!  What the hell!!   I know this will happen again, so im looking to fix it

soo,  the obvious questions.  IS this solenoid? and how do I check it,  or, is it starter, and how would the separation of part that's damaged be determined?

I havnt noticed any plasticy wire burning smells,  car has been running great,,,

Views: 146

Reply to This

Replies to This Discussion

I haven't done this in a long time but auto parts stores used to test starters and solenoids for you. Call your local parts stores and ask if they still do that.

I would double check all wires, including grounds on cranking circuit and make sure car is firmly in park … even jiggling the lever a bit. If not firmly in gear or neutral safety switch is a bit off it will not crank … but usually doesn’t even make a click.

I would check the NSS first. Next time it does it, rock the shifter lever a bit to see if the car starts. 

Russ, Jason,, I m running without a NSS.. the one I got from Russ a while back cracked so Im just in the habit of always checking the park at start and stop,  and not parking behind another car.  

This morning, I went out to give it a go, and it just started right up,, Never flinched, just started.  maybe it just needed a jiggle, but im gonna have to try and see what that was in the next few days,, bad weather coming up here for a couple days, 

Give the connector another squeeze with the pliers to see if it is loose. (the connected wires on the NSS circuit)

I hvnt been able to work on car due to weather. Went out today and it started fine.

My question is, if it is a starter,solenoid problem, is this a progressive condition?  By that i mean will it get worse or just be a hit or mis non start?  Strangely,  my 05 diesl is dead due to a 1295 code, sold the 73 eldo, so the 63 is my primary car that i now trust to start (73 WAS MYBALWAYS START go to) and its gone,  so if its a on off thing till incan get into it fully, i can get by, but if its gonna just die an i getvstranded, i hv to try to figure out some thing quick

RSS

Photos

  • Add Photos
  • View All

Forum

Seam Sealer Locations?

Started by Donald Swenson in 1963/64 Cadillac Specific Discussion. Last reply by Donald Swenson yesterday. 2 Replies

Hello,Just wondering if anyone has photos to where I need to apply new SEM seam sealer on the front of the fenders to the inner top Cowl area and the corners of the Radiator support?I am in the…Continue

Rear Defroster

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb yesterday. 2 Replies

I was watching a YouTube video (I'll attach it below) of a 1964 Fleetwood 60 Special revival and I noticed it was equipped with a rear defrost option (as well as nearly every other option for 1964…Continue

Share your Photos!

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb yesterday. 8 Replies

The wintertime blues are hitting hard as 3-6" of snow is forecasted for later this week. Share your favorite photos of your 63 or 64 Cadillacs! Spring/Summer/Fall cant get here soon enough!Thanks for…Continue

Techniques for replacing pinion seal on differential

Started by allen dilley in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Friday. 2 Replies

My 63 Park Avenue has a leak at the differential.  My accomlished, experienced, and reliable mechanic has never replaced a seal of this type. I have a pinion seal and differential gasket.  I also…Continue

Tags: Replacement, Seal, Pinion

Blog Posts

'63 Tailfin Tales

Posted by Mark Mata on January 14, 2025 at 12:06am 1 Comment

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service