Hey all, both the brake lights on my SDV are not making good connection. Drivers side works but is held tight with a piece of plastic wedged by the bulb and I can't get the right one to light the brake without pushing on it. They're either wore out or the springs are corroded. Tried the WD40 trick but that was an epic fail.

  Has anyone ever replaced any of the  rear light sockets on a '63?? They look like they're part of the tail light assembly. I've read up on how to get to the nuts that hold the assembly in place for removal but haven't found anything on replacing the sockets.

Thanks. Tom B

 

Views: 290

Reply to This

Replies to This Discussion

The sockets are crimped in place. The folded over metal will need to be ground off to get the socket out.

Sounds like a good time to install the LED tail lights from caddy Shack restorations.

OK, thanks guys. Hmmm, I'll have to investigate the LED's 

Tom i bought light sockets at JT&T.com part # 2567F they fit a 3/4 inch hole. I grinded off the old socket removed all the reamaining parts, pressed in the new socket and adjusted the metal tabs.

Cees, Thanks for the heads up on the part #s

Tom B

RSS

Photos

  • Add Photos
  • View All

Forum

Windshield washer pump inoperative

Started by Wayne Morris in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 14 Replies

I have spent a few hours trying to get pump to pump fluid. The lines are all clear, The pump Is working as it should when the washer button is pushed. I have a spare wiper motor assembly which I have…Continue

63 vs 64 Hood V Size Difference

Started by Jason Edge in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies

The 64 hood V is considerably bigger than the 63 hood V, and one of the many things I have not done in dealing with these cars on the last 3 decades was to do a direct comparison. Someone asked about…Continue

Radio Models 1963 to 1968

Started by Jason Edge in 1963/64 Cadillac Specific Discussion on Friday. 0 Replies

I sometimes get asked what radios were used in 1963 and 1964 or verification of a radio model number, so I scanned the radio listing from a 1968 Master Parts Book that covers 63 to 68 which covers…Continue

64: BULB FINALLY INSTALLED BUT CLOCK, GAUGE LIGHT AND RADIO DO NOT ILLUMINATE

Started by Norman Silverman in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 14 Replies

HELLO ALLSo, after 4 hours work to remove and replace the bulb behind the "defrost" on the HVAC panel, the same bulbs that started me doing this are still out-even though I replaced all three of…Continue

Blog Posts

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service