Brake Light- 63 SDV
Hey all, both the brake lights on my SDV are not making good connection. Drivers side works but is held tight with a piece of plastic wedged by the bulb and I can't get the right one to light the brake without pushing on it. They're either wore out or the springs are corroded. Tried the WD40 trick but that was an epic fail.
Has anyone ever replaced any of the rear light sockets on a '63?? They look like they're part of the tail light assembly. I've read up on how to get to the nuts that hold the assembly in place for removal but haven't found anything on replacing the sockets.
Thanks. Tom B
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
The sockets are crimped in place. The folded over metal will need to be ground off to get the socket out.
Sounds like a good time to install the LED tail lights from caddy Shack restorations.
-
Permalink Reply by Tom Bahner on
-
OK, thanks guys. Hmmm, I'll have to investigate the LED's
-
-
Tom i bought light sockets at JT&T.com part # 2567F they fit a 3/4 inch hole. I grinded off the old socket removed all the reamaining parts, pressed in the new socket and adjusted the metal tabs.
-
-
Cees, Thanks for the heads up on the part #s
Tom B
Photos
Members
Forum
Burning Rubber
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Kurt 1 hour ago. 7 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Gas gauge only reads half when full
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue
64 Brakes
Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Heater Core Replacement
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson Feb 15. 6 Replies 0 Likes
I'm currently rounding up parts for a heater core replacement in my 1964 Deville. I'm looking for replacement hoses that connect to the heater core itself. It's a factory a/c car and has the metal…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
