Cadillac 40Amp Fuse
I purchased this fuse. It turns red hot and failed
Is this the correct fuse? The glass fuse works, no problems
I would like a metal fuse, but clearly this one is not good
Where can I get a good one???
- Attachments:
-
-
Cadillac 40Amp Fuse 1.JPG, 704 KB -
Cadillac 40Amp Fuse 2.JPG, 560 KB
-
Replies to This Discussion
-
Permalink Reply by a5c0048011b941599a2e58cc24e9eb2f on
-
What circuit is this for?
-
Permalink Reply by Frank Murch on
-
Windows and convertible top, in the fuse block left side under dash. You can see it if you lay down in the drivers foot well. It is the location of all the fuses
Thanks
-
-
Ok, I know that fuse, but have never had a reason to mess with it.
I'll leave it to more knowledgable people to answer.
Sounds like we shouldn't ever operate the power windows and the top at the same time. (Common sense, too.)
-
-
just listed https://www.ebay.com/itm/266503396737
Members
Forum
Replace Choke Tube or Install Electric Choke?
Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal 20 hours ago. 4 Replies 1 Like
My mechanic has sourced a choke housing and new internals. As you might expect, the choke tube is damaged and or clogged. My options are to either replace the choke tube, or my mechanic recommends…Continue
Tags: Electric Choke, Choke Tube
Correct whitewalls
Started by Richard Stanley in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
I just replaced my tires from Diamondback (I had bad results in the past from Coker). It was the second time, due to the age of the tires. About 18 years ago Diamondback made custom whitewalls…Continue
Dino Radiator Leak - Time to Recore!
Started by Jason Edge in General Discussion. Last reply by Jason Edge yesterday. 35 Replies 0 Likes
I had brought up the topic of radiator leaks as a discussion topic for our Chapter Zoom meet-up this past Sunday and thought I would share on our website for everyone and probably do a more formal…Continue
1963 390 upper heater core hose
Started by Kenneth M Karrer in General Discussion. Last reply by Bill Wolf yesterday. 5 Replies 0 Likes
Hello, My 63 convertible is a low mileage (34k) original car so while I've done some basics, like replacing radiator hoses, belts, and a few gaskets; I've been trying to leave things as is as…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
