Hi Everybody,
In the attached JPEG is a scratch I picked up in October 2016 on one of the last rides of the season by a truck going the opposite way on a 2 lane road. You would have thought someone hurt my kids. Anyway, it is on the front drivers front fender above the trim piece. Any ideas on how to make it look respectable without painting the entire fender?
Tags:
sand to feather the edges. Color match the paint, and lay down some primer and paint with a air gun.
Thanks Russ
Hi Tony the scratch is 1/2 inch long 1/8in wide
Hi Tom If you go to a good auto paint supplier they should have a camera that they put up against the exsiting paint and take a picture which they can match the color on your car. You could take them a fender skirt if easier and they can mix a small sample for you to touch up your scratch. I did this on a fender skirt and it matched amazingly well. Try it on a sample first. Good luck.
Started by Alan Clark in 1963/64 Cadillac Specific Discussion 5 hours ago. 0 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari on Saturday. 3 Replies 0 Likes
for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies 0 Likes
Is anyone here planning on going to the Back to the 50’s car show in Minnesota?
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by