My 1964 429 has a loose water pump pulley. I have taken everything apart four times and still cannot get it to seat tight against the water pump. The shaft on the water pump is still tight with no play. I fear this vibration will ruin the bearings if I do not get this fixed. I am not driving this car until it gets repaired. The four bolts go through the fan blade, spacer , and pulley. They will not go any tighter, yet still the pulley has lots of play. Any advice would be greatly appreciated. Thanks for any help.

Views: 191

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by David Cotton on July 1, 2014 at 12:11pm
Thank you and I have come to the same conclusion. I have not and will not drive or start the car until the water pump is replaced. I ordered one this morning. Thank you all for your time and advice. This is an excellent website for people who love these beautiful cars!
Comment by David Cotton on July 1, 2014 at 12:49am

Nothing was replaced, just noticed play in the water pump pulley. It is a non-ac car. Thanks for your advice. Will keep you posted.

Photos

  • Add Photos
  • View All

Forum

64 Brakes

Started by Jeff Donaldson in General Discussion. Last reply by Logan Robb 1 hour ago. 4 Replies

Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue

Heater Control Valve

Started by Michael Monson in Wanted to Buy 14 hours ago. 0 Replies

Looking for a heater control valve 9.795 for my 1964 Deville.  ThanksContinue

Burning Rubber

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Sunday. 7 Replies

Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light?   Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue

Gas gauge only reads half when full

Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin Feb 18. 1 Reply

Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service