Noisy A/C compressor
I just picked up my '63 Series 62 from the shop yesterday, after it spent 51 days there for repair of various oil leaks. Started it up and turned on the A/C, it ran great for about 30 seconds and blew cold air, but then the compressor started screeching loud enough to bring people running out of the shop. My mechanic looked at it for short time, rotated the clutch back and forth for a bit, and things were okay again. He thought it may have been from sitting too long. I got about 3 miles down the road and it started screeching again. Same deal again this morning. The noise starts when the clutch engages. The belt is not slipping. Any ideas what I am up against? This is a 34,000 mile car, so the A/C components are all original equipment. Thanks!
Replies to This Discussion
-
Permalink Reply by Terry Lange on
-
Thanks for that info, Mark. I checked the '63 shop manual and it says the air gap should be 1/32 to 1/16, and mine is within that range. The center hub also turns smoothly when turned by hand. I'm leaning towards just ordering a clutch plate and hub assembly to start with, as it can be replaced without removing the compressor. Looks like there are many after market ones available on line that claim to fit a '63 Cadillac compressor. Mine is a Frigidaire model 5910438.
-
-
Tony and Ginny 429, I always turned off the A/C at the dash control as soon as it started screaming. But I did take your advice and disconnect the compressor harness this morning, and found out that I can still get outside air through the A/C vents in the car, so that was definitely a bonus. Prior to doing that the only way to get outside air (with the A/C turned off) was to switch the control to heat, but on the coolest setting. The only problem is that the air came in through the floor vents, which wasn't much help. So thank-you for the suggestion.
-
Permalink Reply by Kim K Kaiser on
-
on my 73, it was the bearing, I replaced it, and it stopped,,
Photos
Members
Forum
Burning Rubber
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 20 hours ago. 6 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Gas gauge only reads half when full
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue
64 Brakes
Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Heater Core Replacement
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson Feb 15. 6 Replies 0 Likes
I'm currently rounding up parts for a heater core replacement in my 1964 Deville. I'm looking for replacement hoses that connect to the heater core itself. It's a factory a/c car and has the metal…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
