Jason Edge graciously furnished me with the repair manual supplement for the 1963 Cadillac repair manual. Having reviewed the illustrations and read the instructions, I still cannot figure out how to take apart the turn signal cancellation mechanism. I prefer to avoid removing the steering column to make this repair and seek advice from those of yuo who have attempted this endeavor before me. I shall take photos over the weekend and will mark them up before posting.
If any of you are familiar with this, please rrespond so that I can better understand what I am facing to make this repair. I was hoping that my problem was the bell crank arm (a replacement of which I purchased from Russ Austin). However, my minimal view makes me believe that it is not the problem.
Thank you.
Stephen Pechenik
Tags:
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 11 hours ago. 14 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge 21 hours ago. 6 Replies 0 Likes
First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system. The old system was very good, however, I believe what Bill and the…Continue
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Tuesday. 3 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Tuesday. 7 Replies 0 Likes
Greetings Everyone. I read a discussion thread about "radiator and related", covering coolant overflow. Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac? Is there if a…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by